Abstract:This paper presents a 5-GS/s 12-way 10-b time-interleaved successive approximation register (SAR) ADC for direct sampling receivers. Proper signal and clock distribution along the multiple channels are utilized to mitigate interchannel bandwidth and timing mismatches. A digitally assisted calibration is introduced to remove the interchannel offset, gain, and timing mismatch. The T-type bootstrapped sampling switches minimize the interchannel crosstalk among top-plate sampling SAR channels and the signal-dependent leakage current during SAR conversion cycles. The power efficiency of this ADC is significantly improved by many design techniques. The merged capacitor switching algorithm leads to high switching efficiency and a smaller area. The modified reference voltage scheme optimizes input common-mode voltage of the comparators. The optimal subradix-2 capacitive DAC results in low-power reference buffers and higher conversion speed. This ADC achieves 49-dB SNR, 52-dB THD, and 42-dB SNDR up to Nyquist frequency at 5 GS/s, consumes 76 mW from 1 V supply, and occupies 0.57 mm $^{{ {2}}}$ in 28 nm CMOS technology. The implemented architecture also demonstrates high scalability to advanced CMOS technology nodes and has even higher power efficiency potential.

A 32.5-Gs/s Sampler with Time-Interleaved Track-and-Hold Amplifier in 65-Nm CMOS

A 32.5-GS/s two-channel time-interleaved CMOS sampler with switched-source follower based track-and-hold amplifier

Optimization Of Sample/Hold Circuit For High-Speed And High-Resolution Adcs

Design of a High-Speed Sample-and-hold Circuit Using a Substrate-Biasing-effect Attenuated T Switch

A Low Power Sample-and-Hold Circuit for Pipelined A/D Converter

Compact Low-Power 7-Bit 2.6 GS/s 65 Nm CMOS ADC for 60 GHz Applications

A sample and hold circuit for high speed ADCs

A High Speed Sampler for Sub-Sampling IR-UWB Receiver

A 10-GS/s 8-bit 2× time interleaved hybrid ADC with λ/4 reference T-Line sharing technique

A 5-GS/s 10-b 76-mW Time-Interleaved SAR ADC in 28 nm CMOS

A CMOS high performance 50MS/s sample/hold circuit

A 10-bit 20-Msample/s 49mW CMOS pipelined A/D converter

A 150 MS/s 10-Bit CMOS Pipelined Subranging ADC with Time Constant Reduction Technique.

A CMOS High-Speed Sample-and-Hold Amplifier

A low-power 4.224GS/s sampler in 0.13-μm CMOS for IR UWB receiver

A 14-Bit 4 GS/s Two-Way Interleaved Pipelined ADC with Aperture Error Tunning

A Sub-Sampling 4-Bit 1.056-Gs/s Flash ADC with a Novel Track and Hold Amplifier for an IR-WB Receiver

A 12-Bit 2 GS/s Single-Channel High Linearity Pipelined ADC in 40 nm CMOS

A Quadrature Clock Generator with Calibration for 22&#x223c;31.4 GS/s Real-Time Sampling System

A 12-Bit 200-Ms/s Sample-and-hold Amplifier with a Hybrid Miller-Feedforward Compensation Technique

A 25-Gs/s 6-Bit Time-Interleaved SAR ADC with Design-for-test Memory in 40-Nm Low-Leakage CMOS