Abstract:This article presents a fully differential high-dynamic-range direct-conversion receiver for sub-1-GHz band applications in a 180-nm CMOS technology. The integrated self-adaptive multipart automatic gain control (AGC) loops are designed to cope with large input signal. In the radio frequency (RF) domain, a gain-adjustable noise-canceling balun low-noise amplifier (LNA) and a high-linearity RF variable gain amplifier (VGA) are co-designed to keep a steady differential output power for the mixer stage. In baseband (BB), a novel gain distribution method is proposed to protect BB circuits from saturation. To prove the concept, one of the most typical and strict application scenarios in the sub-1-GHz band, digital television (DTV) standard, is analyzed and chosen as the design target. The receiver achieves a noise figure (NF) of 3.6–4.6 dB in the ultrahigh-frequency (UHF) band. A wide gain tuning range of 128.8 dB is realized in this work, featuring fully integrated AGC loops. The programmable bandwidth of the low-pass filter (LPF) can be adjusted from 1 to 4 MHz, supporting 2-/6-/7-/8-MHz signal channels. The maximum in-band third-order input-referred intercept point (IIP3) is 10 dBm under the conversion gain of 0 dB. The receiver consumes 49.56 mA from a 1.8-V voltage supply and occupies an area of 3.56 mm2.

A Sub-Sampling 4-Bit 1.056-Gs/s Flash ADC with a Novel Track and Hold Amplifier for an IR-WB Receiver

A Sub-Sampling 4.25 GS/s 3-Bit Flash ADC with Asymmetric Spatial Filter Response

A TD-ADC for IR-UWB Radars with Equivalent Sampling Technology and 8-Gs/s Effective Sampling Rate

Design of 4-bit parallel sub-sampling A/D converter for IR-UWB receiver.

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A 14-Bit 500-Ms/S Sha-Less Pipelined Adc In 65nm Cmos Technology For Wireless Receiver

Design of A Parallel Low Power Flash A/D Converter for the Sub-Sampling Ir-Uwb Receiver

A High Speed Sampler for Sub-Sampling IR-UWB Receiver

Compact Low-Power 7-Bit 2.6 GS/s 65 Nm CMOS ADC for 60 GHz Applications

A Low-power Sub-sampler in 0.13 μm CMOS for IR UWB Receiver

Low-power 4 B 2 GHz Flash ADC for Ultra-Wideband Communications

A low-power 4.224GS/s sampler in 0.13-μm CMOS for IR UWB receiver

A 6-Bit Low Power Flash ADC with a Novel Bubble Error Correction Used in UWB Communication Systems

All-digital Sub-sampling Architecture for an Impulse Radio Ultra Wideband Receiver

A 32.5-GS/s two-channel time-interleaved CMOS sampler with switched-source follower based track-and-hold amplifier

A Single Channel, 6-Bit 410-Ms/s 3bits/stage Asynchronous Sar Adc Based on Resistive Dac

A 1.8-V 22-Mw 10-Bit 30-Ms/s Subsampling Pipelined CMOS ADC.

A 14-Bit 4 GS/s Two-Way Interleaved Pipelined ADC with Aperture Error Tunning

A Sub-Sampling 3-Bit 4gs/s Flash ADC in 0.13-&Amp;#x00b5;m CMOS

A 4gs/s 3b Two-Way Time-Interleaved ADC in 0.13um CMOS.

A 42fj 8-Bit 1.0-Gs/s Folding and Interpolating ADC with 1ghz Signal Bandwidth