Abstract:>A sub-sampling 4-bit 1.056-GS/s flash ADC with a novel track and hold amplifier(THA) in 0.13μm CMOS for an impulse radio ultra-wideband(IR-UWB) receiver is presented.The challenge is in implementing a sub-sampling ADC with ultra-high input signal that further exceeds the Nyquist frequency.This paper presents,to our knowledge for the second time,a sub-sampling ADC with input signals above 4 GHz operating at a sampling rate of 1.056 GHz.In this design,a novel THA is proposed to solve the degradation in amplitude and improve the linearity of signal with frequency increasing to giga Hz.A resistive averaging technique is carefully analyzed to relieve noise aliasing.A low-offset latch using a zero-static power dynamic offset cancellation technique is further optimized to realize the requirements of speed,power consumption and noise aliasing.The measurement results reveal that the spurious free dynamic range of the ADC is 30.1 dB even if the input signal is 4.2 GHz sampled at 1.056 GS/s.The core power of the ADC is 30 mW,excluding all of the buffers,and the active area is 0.6 mm 2 .The ADC achieves a figure of merit of 3.75 pJ/conversion-step.

Low-power 4 B 2 GHz Flash ADC for Ultra-Wideband Communications

A 2-Bit 4gs/s Flash A/D Converter in 0.18 &#x03bc;m CMOS for an IR-UWB Communication System

A pseudo-2bit 4-GSps flash ADC in 0.18µm CMOS for an IR-UWB communication system

A 6-Bit Low Power Flash ADC with a Novel Bubble Error Correction Used in UWB Communication Systems

Design of A Parallel Low Power Flash A/D Converter for the Sub-Sampling Ir-Uwb Receiver

A 40-Mw 7-Bit 2.2-Gs/s Time-Interleaved Subranging ADC for Low-Power Gigabit Wireless Communications in 65-Nm CMOS

A 40-mW 7-bit 2.2-GS/s Time-Interleaved Subranging CMOS ADC for Low-Power Gigabit Wireless Communications.

Ultralow Power K-Band Frequency Doubler with Differential Output

Compact Low-Power 7-Bit 2.6 GS/s 65 Nm CMOS ADC for 60 GHz Applications

A Sub-Sampling 4-Bit 1.056-Gs/s Flash ADC with a Novel Track and Hold Amplifier for an IR-WB Receiver

A 700uW 1GS/s 4-bit Folding-Flash ADC in 65nm CMOS for Wideband Wireless Communications

A Sub-Sampling 4.25 GS/s 3-Bit Flash ADC with Asymmetric Spatial Filter Response

Design of 4-bit parallel sub-sampling A/D converter for IR-UWB receiver.

A Low Power 1G-Samples/s, 6-Bit Folded Interpolation ADC Integrated Circuit Design

A 3.65 mW 5 bit 2GS/s flash ADC with built-in reference voltage in 65nm CMOS process

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

A subthreshold ultra low power 22fJ/conversion flash ADC for RFID sensing applications

A TD-ADC for IR-UWB Radars with Equivalent Sampling Technology and 8-Gs/s Effective Sampling Rate

A low-power 4.224GS/s sampler in 0.13-μm CMOS for IR UWB receiver

A Low-power Sub-sampler in 0.13 μm CMOS for IR UWB Receiver

A Fully-Integrated Cmos Uwb Transceiver for Ultra-Low-Power Short-Range Application