Abstract:Ring amplifier has been shown as an alternative to an OTA for its low power consumption and large output swing in low-voltage, deep nanoscale CMOS processes. The robustness of the ring amplifier is an important consideration for its application in products. A transient amplification analysis in this paper reveals the difference between the DC gain and the effective gain of the ring amplifier at different output voltages. This non-linear gain error varies with process corner, supply voltage and temperature (PVT) variation. To compensate this gain error, a calibration method is proposed based on the code density analysis of the output data from the back-end stages. Designed in a 1 V 28 nm CMOS process, a prototype SAR assisted pipeline ADC is proposed with a quick-start ring amplifier. The 12-bit ADC achieves 59.3 dB SNDR and 74.4 dB SFDR with a 6 MHz input and a sample rate up to 625 MS/s. The ADC has measured SNDR and SFDR of 57.2 dB and 67.8 dB, respectively, for a Nyquist frequency input and consumes 13.2mW. The measured SNDR and SFDR remains above 53.5 dB and 66.3 dB for a -6dBFs 50 MHz input with supply voltage and temperature variation.

High gain, high speed OTA for S/H circuit in 14-b 100-MS/s Pipeline ADC

A Low Power Sample-and-Hold Circuit for Pipelined A/D Converter

Low power design for 14-bit 100MSPS pipelined ADC

High-speed and high-gain operational amplifier

High-Speed Operational Amplifier Based on 0.5 Μm CMOS Process

High-Gain and Wide Bandwidth Gain-Boosting OTA

A sample and hold circuit for high speed ADCs

Design of a gain-boosted telescopic operational amplifier

A 1.2V Sample-and-Hold Circuit for 14-Bit 250MS/s Pipeline ADC in 65nm CMOS

A High Linearity 14-Bit 40 MS/s Pipelined A/D Converter

A 10-bit 20-Msample/s 49mW CMOS pipelined A/D converter

A 10-Bit 100-Msps Low Power Time-Interleaved ADC Using OTA Sharing

A 0.5-V 0.02% THD Bulk-Driven OTA for Continuous-Time Applications in 180 nm CMOS

Modeling and Designing of High-Gain, Wide-Band and Fast-Speed Operational Transconductance Amplifier

A 625ms/s, 12-Bit, SAR Assisted Pipeline ADC with Effective Gain Analysis for Inter-stage Ringamps

A Highly Linear 1.2 V 12bit 5–45 MS/s CMOS Pipelined ADC with CM-sensing-and-input-interchanged OTA Sharing

A Take/Hold Circuit for High Speed & Resolution ADC

Analysis and Design of Fully Differential Gain-boosted OPAMP Dedicated to 14 Bit Sample-and-Hold Circuit

A 12-Bit 2 GS/s Single-Channel High Linearity Pipelined ADC in 40 nm CMOS

A 0.22 pJ/step subsampling ADC with fast input-tracking sampling and simplified opamp sharing

A 94.6Db-Sndr 50Khz-Bw 1-1-1 MASH ADC Using OTA-FIA Based Integrators