Abstract:The residual stress of mismatch seal between borosilicate glass 3.3 and stainless steel is analyzed for metal–glass solar evacuated tubes in this paper. As borosilicate glass has a much lower limit of stress than metal, a tube model with different sizes and shapes of metal and glass is simulated to determine the magnitude and profile of the residual stress in the glass region. The simulation results show that the maximum magnitude of the hazardous tensile stresses occurs at a few millimeters above the sealing area, not in the contact position; and the thickness of metal is the most important parameter of the seal which affects the stress level. The stress magnitude increases dramatically when the thickness of stainless steel increases from 10 to 60µm. Therefore, to avoid breakage of the seal, the thickness of metal should be less than 40µm. In addition, it is shown that both the cross-section shape of the metal ring and the contact length in the glass have a considerable impact on the stress. The stress level increases significantly with the increase of depth of the metal ring embedded in the glass. Comparison between a metal ring with trapezoidal cross-section and one with rectangular cross-section of equivalent mean thickness reveals that the former leads to smaller residual stress. Furthermore, the results show that variation in the glass tube dimensions, in compare to the metal ring parameters, has less effect on the residual stress level in the seal area. An increase in the thickness of the glass tube decreases the stress noticeably, whereas an increase in tube radius has a negligible impact. Finally, it is shown that the simulation results are in good accordance with results of experiments using samples of mismatch seal between borosilicate glass 3.3 and stainless steel successfully fabricated according to our proposed parameters.

Analysis of Effect Factors on Residual Stresses Within Glass Tube to Kovar Alloy Brazed Joint

Analysis of Influence Parameters on Residual Stress in Glass-to-metal Vacuum Brazing Flat Joint

EXPERIMENTAL RESEARCH AND FINITE ELEMENT ANALYSIS ON A WELDED JOINT WITH TUBES INTERSECTED AT TWO DIFFERENT POINTS

Application of Orthogonal Test in Numerical Simulation of Glass Lens Molding

Theoretical Study on Residual Thermal Stresses Caused by the Brazing Process in Annular and Bilayer Structures

Analysis on Influence of Welding Residual Stress on Ultimate Bearing Capacity of Y-j oints

Effect of Post-Weld Heat Treatment on the Plastic Buckling of Welded Cylindrical Shells

Analysis of residual stress for mismatch metal–glass seals in solar evacuated tubes

Numerical Simulation of Residual Stress in the Glass-to-Metal Diffusion Seals

Study on vacuum brazing of glass to kovar® alloy with Cu-Ni-Sn-P

Effect of welding residual stress on the performance of CFST tubular joints

Numerical investigation on the effect of copper filler thickness on the brazed residual stress

Optimization of Laser Glazing Parameters for Reduction of Residual-Stress

Effect of Process Conditions on Residual Stress in Laser-MAG Welding of High Strength Steel

Effect of joint design on residual stresses in AISI-304 stainless steel weldment - a numerical study

Residual Stress of Laser Welding Joint of Stainless Steel Automobile Vent Pipel

Influence of restraint conditions on residual stress and distortion of 2219-T8 aluminum alloy TIG welded joints based on contour method

Experimental and numerical study of the flaring process for Zircaloy tube end

Optimized Sealing Process And Real-Time Monitoring Of Glass-To-Metal Seal Structures

Analysis on Influence Factors of Axial Strength of Circular Tubular TX-and TT-joints

Numerical Investigations on Residual Stress in Laser Penetration Welding Process of Ultrafine-Grained Steel