Abstract:Flanging of pipe fittings is widely used in the industrial field. Flanging die is used in the traditional process, which has poor flexibility and high cost. Progressive forming is a process for forming tubular parts developed in recent years. A multi-pass progressive flanging process of round metal tube ends with ball-end tool bar as the forming tool is introduced, and dieless flanging of tubes can be realized by means of numerical control machine. Based on the process of multi-pass progressive flanging of round tubes, an analytical model of the forming force (axial, radial, and tangential) is established by taking the micro-element contacting tool bar with tube as the research object. Additionally, numerical simulation with the commercial ABAQUS is conducted complementarily to reveal the stress and strain evolution during the flanging process. An experimental work is conducted to investigate the forming force of the flange process of copper tubes. A comparison between forming loads analytically and experimentally is discussed; the mechanism of the flanging force in the multi-pass progressive flanging process of metal tube end is studied. The radial and axial forces in the forming process are related to the current flanging angle and the angle increment of each pass. When the flanging angle is greater than 30°–40°, the axial forming force becomes the largest, followed by the radial forming force. The comparison indicates that error between the radial forming force obtained by theory and simulation and by experiment is within 5%, and that of the axial forming force is less than 20%. Moreover, the flange thinning is discussed. The results show that the flanging flange is thinned evenly in the middle region, outermost edge of flange is thinned seriously, and the thinning rate is about 48%.

Experimental and numerical study of the flaring process for Zircaloy tube end

Modeling and analysis of multi-pass progressive flanging force of copper tube end

Evolution of microstructure, microhardness and surface roughness of Al alloy thin-walled tube during flaring process

Flange Forming at an Arbitrary Tube Location Through Upsetting with a Controllable Deformation Zone

Numerical and experimental study on in-plane bending of microchannel aluminum flat tube

EXPERIMENTAL STUDY OF THE BEARING CAPACITY OF INTERNAL|EXTERNAL FLANGE JOINTS SUBJECTED TO PRESSURE AND BENDING LOADINGS WITH VARIOUS ECCENTRICITIES

FE Modeling of Warm Flanging Process of Large T-pipe from Thick-Wall Cylinder

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

A Theoretical Study of the Expansion Metal Tubes

Research on thinning spinning flaring for thin-walled tube

Influence of mechanical properties of tube on forming limits and deformation characteristics in expansion drawing process

Study on Experimental Approaches of Forming Limit Curve for Tube Hydroforming

Cold and warm flaring of thin-walled titanium tube using single-point incremental forming

Formability Enhancement in Titanium Tube-Flaring by Manipulating the Deformation Path

Numerical and Experimental Study on Expansion Forming of Inner Grooved Tube

Fabrication of Curved Generatrix Workpiece of Ta15 Titanium Alloy by Variable Thickness Tube Spinning and Flaring Process

Influence of process parameters on the flow forming quality of thin-walled tube with large diameter-thickness ratio

Plastically Deformed Tubes Subjected to Mechanical Expansion Processes

Study on the Crushing and Hydroforming Processes of Tubes in a Trapezoid-Sectional Die

The Numerical and Analytical Study on Stretch Flanging of V-Shaped Sheet Metal

Finite-element Modelling of a Novel Flanging Process on a Cylinder with a Large Diameter–thickness Ratio