Abstract:The manufacturing process is inevitably accompanied with the production of scraps, which leads to resource waste and environmental pollution. Recycling and remanufacturing are the most commonly used approaches for metal scraps due to their well-established advantages from economic and environmental perspectives. In this study, spinning experiments with 2195 Al-Li alloy tailor welded blanks produced by friction stir welding from metal scraps were conducted under different process parameter designs. And then the effects of various process parameters on spinning of thin-walled curved surface parts were systematically studied. The results of the corresponding experimental groups show that the roller attack angle, the spinning clearance, and the installation method of tailor welded blanks have the most significant effect on the weld torsion angle. In addition, it was found that along the longitude direction of spun parts, the surface roughnesses of the weld of spun parts were greatly improved under the roller nose radius of 10 mm, the spinning clearance of 1.0 mm, the constant linear velocity, and the installation method of tailor welded blanks (the lower surface of tailor welded blanks is spun by rollers), while the process parameters have little significant effect on the surface roughness along the latitude direction of spun parts. Furthermore, it can be concluded that the forming profiles of spun parts fitted the mandrel well under the roller nose radius of 6 mm, double rollers, the roller attack angle of 30° and 45°, spinning clearance of 1.5 mm, and the installation method of tailor welded blanks (the upper surface of tailor welded blanks is spun by rollers). The research results will provide guidance for the precise spinning of thin-walled curved surface parts with tailor welded blanks. Thereby, it is also beneficial for green manufacturing involving recycling and remanufacturing of metal scraps.

Research on thinning spinning flaring for thin-walled tube

Numerical Simulation Research on A New Spinning Process: Double-Roller Clamping Spinning Process

Study on the spinning process of thin-walled aluminum alloy vessel head

Experimental and numerical study of the flaring process for Zircaloy tube end

Evolution of microstructure, microhardness and surface roughness of Al alloy thin-walled tube during flaring process

Spinning Process of 2219 Aluminum Alloy Tubes for Used in Hydroforming

Study on Flange-Constrained Spinning Process for Hemispherical Aluminum Alloy Part

Numerical simulation and experimental study on non-axisymmetric spinning with a groove at the middle of the tube

A Systematic Study on the Effects of Process Parameters on Spinning of Thin-Walled Curved Surface Parts With 2195 Al-Li Alloy Tailor Welded Blanks Produced by FSW

Finite Element Analysis of Stress and Strain Field in Thin-wall Taper Workpiece During Spinning Forming

Finite element simulation of backward ball spinning of thin-walled tube with longitudinal inner ribs

Study on Spinning Process of A Thin-Walled Aluminum Alloy Vessel Head with Small Ratio of Thickness to Diameter

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Influence of process parameters on the flow forming quality of thin-walled tube with large diameter-thickness ratio

A Study of Severe Flange Wrinkling in First-Pass Conventional Spinning of Hemispherical Part

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

Spiral forming and cross-section deformation behaviors of finned special-shaped tube

Study of Dieless Radial Spinning for Thick-Walled Cylindrical Parts With External Grooves

Modeling and analysis of multi-pass progressive flanging force of copper tube end

Analysis of ball spinning formability of thin-walled tubular parts of aluminum alloy

Influence of Friction Stir Weld Seam Distribution on Spun Formed Workpieces