Abstract:A hot-working die steel thick-walled tube Pilger rolling test was carried out using an LG40 Pilger mill, and the morphology and roughness evolution of the inner surface were examined using a white-light interferometer. The experimental results showed that micro-wrinkles formed on the basis of the original inner surface morphology, the altitude difference (Sz) between the peaks and valleys of the inner surface profile increased from 3.18 to 3.686 μm, and Sa increased from 0.722 to 0.892 μm in the diameter reduction zone. As the tube continued to feed into the wall thickness reduction zone, the micro-wrinkles gradually flattened, Sz and Sa were decreased to 1.625 and 0.174 respectively, and Sa maintained a slight fluctuation of 0.174~0.2 μm in the final sizing zone. From the diameters of the roller groove and taper of the mandrel, the three-dimensional strain of the tube in the wall thickness reduction zone was calculated, and the strain state of the tube in the complete deformation zone could be analyzed by finite element simulations. We found that in the diameter reduction zone, the inner surface was not supported by the mandrel and was free, while micro-wrinkles formed under circumferential compressive strain. In the wall thickness reduction zone, the deformation of the inner surface was controlled by the mandrel, and the micro-wrinkles were gradually flattened by radial compressive strain. The ratio of radial to circumferential strain was the key to flattening the micro-wrinkles, and when the ratio increased, the inner surface roughness (Sa) was reduced to 0.174 μm. In the sizing zone, the radial and circumferential strains were small, and the inner surface roughness showed no obvious fluctuation.

A Study of Influence of Interference Phenomenon on Stagger Spinning of Thin-Walled Tube

Three-dimensional Finite Element Analysis of Effects of Roller Intervals on Tool Forces and Wall Thickness in Stagger Spinning of Thin-Walled Tube

A Study of 3D Finite Element Modeling Method for Stagger Spinning of Thin-Walled Tube

Influence of Inner Roller Geometric Parameters on Counter-Roller Spinning with 6061 Aluminum Alloy Tube

The Analytical Model of Ball-Spinning Force for Processing an Annular Groove on the Inner Wall of a Steel Tube

Numerical simulation and experimental study on non-axisymmetric spinning with a groove at the middle of the tube

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Plasticity Improvement of Ball-Spun Magnesium Alloy Tube Based on Stress Triaxiality

Elongation Control of the Ultra-Thin Tinplate During Two-Stand Temper Rolling Unsteady Process

Research on thinning spinning flaring for thin-walled tube

An Investigation of the Temperature Distributions Inside A Spool Valve Owing to A Viscous Heating Effect

On Interference Between Two Circular Cylinders in Staggered Arrangement at High Subcritical Reynolds Numbers

An Investigation for the Friction Torque of a Tapered Roller Bearing Considering the Geometric Homogeneity of Rollers

Inner Surface Morphology and Roughness Evolution of Pilgering Thick-Walled Tubes

Numerical Investigation of Effects of Deformation Allocation on Multi-Pass Conventional Spinning Process of Curvilinear Generatrix Parts

Finite element simulation of backward ball spinning of thin-walled tube with longitudinal inner ribs

Influence of Process Fluctuations on Residual Stress Evolution in Rotary Swaging of Steel Tubes

A Numerical Study of the Effects of Roller Paths on Dimensional Precision in Die-Less Spinning of Sheet Metal

Influence of process parameters on the flow forming quality of thin-walled tube with large diameter-thickness ratio

Influence of mechanical properties of tube on forming limits and deformation characteristics in expansion drawing process

Process factors influencing spinning deformation of thin-walled tubular part with longitudinal inner ribs