Abstract:Accurate prediction of welding residual stresses is often challenging due to the complexity of the welding process which includes moving heat source, temperature-dependent material properties etc. Over the past two decades or so, the numerical simulation technologies have been widely used in the welding process and a number of numerical models have been proposed to predict temperature field and residual stresses field induce by welding process. In the previous numerical simulations, the weldment was either in Free State or rigidly constrained. Such manipulations can not reflect the realistic constraint conditions of the weldment. In this simulation, clamps and backing board are all included in the model as elastic body and analytical rigid body, respectively. In the thermal analysis, the thermolysis of clamps and backing board can be equivalent to forced convection heat transfer, where the coefficients of forced convection heat transfer are temperature dependent; in the mechanical analysis, both the contact interaction between clamps and weldment and the contact interaction between backing board and weldment are considered, normal and tangent contact interaction properties are assumed as "HARD" contact and Coulomb friction, respectively. After welding process, residual compressive plastic strains existing in the weld zone and HAZ are the sources of residual stresses. Post welding cold rolling is an effective and convenient method to reduce residual compressive plastic strains induces by welding especially for thin-walled structure. In the previous researches, either welding process and cold rolling process were treated as two separate processes or only the residual stresses induced by welding process was considered as initial condition in the cold rolling process. In this simulation, welding residual stresses, plastic strains and deformations are all imported as the initial state of the cold rolling process to increase the accuracy of the numerical simulation. The import of plastic strains will affect the accuracy of the numerical simulation for the material which has obvious work harden effect.

Study on Numerical Simulation for Control of Winding Process of Thin Wall Spiral Tube

A Study on Numerical Simulation of Hydroforming of Aluminum Alloy Tube

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

3D Rigid–plastic FEM Numerical Simulation on Tube Spinning

Finite element synthesized analysis of the forming process of spiral welded pipe

Spinning Process of 2219 Aluminum Alloy Tubes for Used in Hydroforming

Numerical simulation of small section rectangular tube in parallel welding

Elastic-Plastic Numerical Analysis of the Spinning Process of SA-372 Steel Used in High-Pressure Hydrogen Storage Cylinders (≥100 MPA)

Wrinkle Analysis and Control of Tube Bending for Hydroforming

Control and use of wrinkles in tube hydroforming

Simulation and the Experimental Analysis on Wrinkling at Flat Tube Rotary Bending In-Plane

Study on the spinning process of thin-walled aluminum alloy vessel head

Study on Wrinkling Behavior in Hydroforming of Large Diameter Thin-Walled Tube Through Local Constraints

Spiral forming and cross-section deformation behaviors of finned special-shaped tube

Numerical Analysis for Forming Limit of Welded Tube in Hydroforming

High precision modeling of welding and post welding cold rolling continuous process in numerical simulation

Consolidation and Warpage Deformation Finite Element Analysis of Filament Wound Tubes

Investigation into Wrinkling Behavior of Thin-Walled 5a02 Aluminum Alloy Tubes under Internal and External Pressure

Numerical Simulation for Continuous Extrusion Process of the Flat Multi-Hole Aluminum Tubes

Wrinkling Behavior in Tube Hydroforming Coupled with Internal and External Pressure

Influence of process parameters on the flow forming quality of thin-walled tube with large diameter-thickness ratio