Abstract:Residual stress in welded structures causes distortion. Severe problems in welded structures leading to failure can be due to uneven distribution of plastic and thermal strain. In the present investigation, Gas Metal Arc Welding of carbon steel (ASTM 36) has been simulated and analysed using Numerical methods. Finite element software ANSYS workbench has been used for the analysis of butt welding of two similar plates. 3-D FEM has been carried out to predict the temperature profile, residual stress distribution and distortion produced during single-pass GMAW process. Also, the effect of variation of convective film coefficients (h) on the distribution and magnitude of the welding residual stresses has been simulated. The analysis includes a time-varying moving heat source, material deposition, temperature-dependent material properties, temperature-dependent plasticity and elasticity properties, transient heat transfer and mechanical behaviour. The temperature-dependent properties of ASTM 36 have been taken from standard data source and that are described up to liquid phase. A 20 node tetrahedral (solid 90) thermal solid has been considered for the thermal analysis, whereas an 8 node (solid 185) solid is used for structural analysis. Both the effects of conduction and convection have been considered in the present work. A sequential coupled thermo-mechanical analysis has been used in this study, and to simulate the filler material deposition, “element birth and death technique” which is introduced to incorporate non-linearity in the model, has been adopted. From this present analysis, the angular distortions have been seen due to the clamping constraint used in the model, but they are insignificant. The lowest value of equivalent stress and the maximum value of angular distortion has been found out for the same value of convective film coefficients (h) which is 500 W/m2 °C.

Numerical Simulation of Tube-Plate Welding Structure with T-Shaped Sections

Nonlinear Transient Analysis of Butt Welding Based on Finite Element Method

Finite element simulation of welding process and real-time monitoring assessment

Finite element simulation of temperature field for TIG butt welding of thin plate

Three Dimensional Numerical Simulation of Temperature and Stress Distribution in Welding of Thick Plate

Sensitivity Analysis of Some High Efficiency Computational Methods for Welding Process Numerical Simulation

Numerical Simulation for Full-Penetration Electron Beam Welding of Ti2AlNb Alloy

Numerical Simulation of Tube Manufacturing Consisting of Roll Forming and High-Frequency Induction Welding

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

Thermal, metallurgical and mechanical analysis of circumferentially multi-pass welded P92 steel pipes

Numerical simulation and analysis of welding of drive axle housing and axle tube

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Numerical Simulation of Residual Stresses in Multipass Gas Metal Arc-Welded Joints of Thick Aluminum Alloy Plates

Numerical Study on Fatigue Behavior of Tubular Joints for Signal Support Structures

3D Finite Element Numerical Simulation of Residual Stresses on Electron Beam Welded BT20 Plates

3D-FEM numerical simulation of welding stress in thin aluminum alloy plate

Welding Numerical Simulation Analysis of AP 1000 Insert Plate and Penetration Sleeves Based on ABAQUS

Numerical simulation of thermal and residual stress fields induced by lined pipe welding

Study on FEM Numerical Simulation Method for the Welding Distortion

Numerical Simulation of Welding for Residual Stress Prediction of Low Carbon Steel

Three-dimensional finite element simulation of residual stresses in circumferential welds of steel pipe including pipe diameter effects