Abstract:Optically transparent materials with p-type electrical conductivity can facilitate the development of transparent electronics and improve the efficiency of photovoltaic solar cells. Sulfide materials represent an interesting alternative to oxides for these applications due to better hole transport properties. Here, transparent and conductive Ba-Cu-S thin films are prepared by combinatorial cosputtering and characterized for their composition, structure, and optoelectronic properties. The conductivity and transparency of these films are found to be strongly dependent on their chemical composition and the substrate temperature during growth. The conductivity of BaCu2S2 and BaCu4S3 can reach 53 S/cm (at 250 degrees C) and 74 S/cm (at 200 degrees C), respectively, which is higher than their solution processed/bulk counterparts. The 90% reflectance corrected transmittance is achieved in the wavelength range 600-1000 nm for BaCu2S2 and 650-1000 nm for BaCu4S3 (at 250 degrees C). These electrical optical properties are comparable with other recently presented transparent p-type conductors, while the 200-350 degrees C processing temperature is low enough to be used in semiconductor devices with limited thermal budgets. Attempts have been made to synthesize the related Sr-Cu-S materials, following the theoretical suggestion of their potential as transparent p-type conductors, but these attempts resulted only in phase-separated SrS and CuxS phases. Alloying BaCu2S2 with Sr on the Ba site on the other hand increases the conductivity to >100 S/cm while only slightly compromising the transparency of the material. To explain the difference between the Ba and the Sr containing copper sulfides, the lower bounds on the SrCu2S2 and SrCu4S3 formation enthalpies are estimated. While the doping of the Ba-Cu-S materials presented here is too large for application in transparent electronics, it is promising for potential use as p-type contact layers in thin film solar cells.

1.37×102 S·cm-1 P-Type Conductivity LaCuOS Films with a Very Wide Optical Transparency Window of 400-6000 Nm

Effect of Hole Effective Mass and Carrier Concentration on the Conductivity of a Transparent P‐type LaCuOS Semiconductor with Good Transmittance in Both Visible and Mid‐Infrared Ranges

High-Performance p-Type Transparent Conducting CuI−Cu2O Thin Films with Enhanced Hole Mobility, Surface, and Stability

Activating P-Type Conduction and Visible Transparency in Delafossite CuAlO2 Films: the Critical Role of the Copper Valence State Transition

Optical Transparency, Carrier Mobility, and Electrical Conductivity of La-based Copper Layered Oxychalcogenides: A Density Functional Theory Study

Amorphous Transparent Cu(S,I) Thin Films with Very High Hole Conductivity

High Optical Transmittance and Anomalous Electronic Transport in Flexible Transparent Conducting Oxides Ba0.96La0.04SnO3 Thin Films

A P-type mid-infrared transparent semiconductor LaSe 2 film with small hole effective mass and high carrier concentration

Transparent and conductive oxide films of the perovskite La xSr1-xSnO3 (x ≤ 0.15): Epitaxial growth and application for transparent heterostructures

A P-type Mid-Infrared Transparent Semiconductor LaSe2 Film with Small Hole Effective Mass and High Carrier Concentration

Epitaxial Bi<sub>2</sub>Sr<sub>2</sub>CuOu<sub> <i>y</i> </sub> thin films as p-type transparent conductors

Highly Enhanced P-Type Electrical Conduction in Wide Band Gap Cu1+xAl1−xS2 Polycrystals

Epitaxial Bi<sub>2</sub>Sr<sub>2</sub>CuO<sub> <i>y</i> </sub> thin films as p-type transparent conductors

A Transparent p-Type Semiconductor Designed via a Polarizability-Enhanced Strongly Correlated Insulator Oxide Matrix

Transparent and conductive oxide films of the perovskite La<sub><i>x</i></sub>Sr<sub>1−<i>x</i></sub>SnO<sub>3</sub>(<i>x</i>⩽ 0.15): epitaxial growth and application for transparent heterostructures

Deep UV Transparent Conductive Oxide Thin Films Realized Through Degenerately Doped Wide-Bandgap Gallium Oxide

Highly Conductive p-Type Transparent Conducting Electrode with Sulfur-Doped Copper Iodide

Optoelectronic Properties of Strontium and Barium Copper Sulfides Prepared by Combinatorial Sputtering

Pulsed laser deposition of single phase n- and p-type Cu2O thin films with low resistivity

Preparation of P-type LaSe2 Films with Conductivity and Mid-Infrared Transparency by Combining Magnetron Sputtering and Selenized Annealing

TRANSPARENT AND CONDUCTIVE OXIDE FILMS WITH PEROVSKITE-TYPE STRUCTURE:LaSrTiO_3