Abstract:Optically transparent materials with p-type electrical conductivity can facilitate the development of transparent electronics and improve the efficiency of photovoltaic solar cells. Sulfide materials represent an interesting alternative to oxides for these applications due to better hole transport properties. Here, transparent and conductive Ba-Cu-S thin films are prepared by combinatorial cosputtering and characterized for their composition, structure, and optoelectronic properties. The conductivity and transparency of these films are found to be strongly dependent on their chemical composition and the substrate temperature during growth. The conductivity of BaCu2S2 and BaCu4S3 can reach 53 S/cm (at 250 degrees C) and 74 S/cm (at 200 degrees C), respectively, which is higher than their solution processed/bulk counterparts. The 90% reflectance corrected transmittance is achieved in the wavelength range 600-1000 nm for BaCu2S2 and 650-1000 nm for BaCu4S3 (at 250 degrees C). These electrical optical properties are comparable with other recently presented transparent p-type conductors, while the 200-350 degrees C processing temperature is low enough to be used in semiconductor devices with limited thermal budgets. Attempts have been made to synthesize the related Sr-Cu-S materials, following the theoretical suggestion of their potential as transparent p-type conductors, but these attempts resulted only in phase-separated SrS and CuxS phases. Alloying BaCu2S2 with Sr on the Ba site on the other hand increases the conductivity to >100 S/cm while only slightly compromising the transparency of the material. To explain the difference between the Ba and the Sr containing copper sulfides, the lower bounds on the SrCu2S2 and SrCu4S3 formation enthalpies are estimated. While the doping of the Ba-Cu-S materials presented here is too large for application in transparent electronics, it is promising for potential use as p-type contact layers in thin film solar cells.

Optoelectronic Properties of Strontium and Barium Copper Sulfides Prepared by Combinatorial Sputtering

Preparation and characterization of sol–gel derived copper–strontium–oxide thin films

Enhancement of Solar Energy Absorption and Optoelectronic Properties of SrCuSbS3 by Lead Doping

Observation and enhancement through alkali metal doping of p-type conductivity in the layered oxyselenides Sr2ZnO2Cu2Se2 and Ba2Zn1-xO2--xCu2Se2

Cs‐Doped and Cs‐S Co‐Doped CuI p‐Type Transparent Semiconductors with Enhanced Conductivity

Barium concentration controlled phase evolution in molecular solution processing of Cu 2 BaSnS 4 thin films for solar cells with improved optical and electrical properties

Copper‐alloyed ZnS As a P‐type Transparent Conducting Material

Bright Luminescence of Sb Doping in All-Inorganic Zinc Halide Perovskite Variant

Insights on the electronic structure of Tin (II) pyrochlore oxides with 5s2 lone pair states as transparent p-type oxide semiconductors

Electron Density and Optoelectronic Properties of Copper Antimony Sulphur Ternary Compounds for Photovoltaic Applications

Activating P-Type Conduction and Visible Transparency in Delafossite CuAlO2 Films: the Critical Role of the Copper Valence State Transition

P-type conductive BaZrS3 thin film and its band gap tunning via Ruddlesden-Popper Ba3Zr2S7 and titanium alloying

High-Performance p-Type Transparent Conducting CuI−Cu2O Thin Films with Enhanced Hole Mobility, Surface, and Stability

High Performance, Low Temperature Solution-Processed Barium and Strontium Doped Oxide Thin Film Transistors

Perovskite Ba(Sr)SnO3: Promising Transparent Conducting Oxides

Ultralow Glassy Thermal Conductivity and Controllable, Promising Thermoelectric Properties in Crystalline o-CsCu5S3

Fabrication of BaZrS3 chalcogenide perovskite thin films for optoelectronics

Designing Optically Transparent and Electrically Conducting BaSnO3 and SrSnO3 Perovskite Oxide Compounds Using First-Principles Calculations

Tuning Optical Properties of Transparent Conducting Barium Stannate by Dimensional Reduction

Bismuth and Antimony Based Oxyhalides and Chalcohalides as Potential Optoelectronic Materials

Alloying ZnS in the hexagonal phase to create high-performing transparent conducting materials