Abstract:Optically transparent materials with p-type electrical conductivity can facilitate the development of transparent electronics and improve the efficiency of photovoltaic solar cells. Sulfide materials represent an interesting alternative to oxides for these applications due to better hole transport properties. Here, transparent and conductive Ba-Cu-S thin films are prepared by combinatorial cosputtering and characterized for their composition, structure, and optoelectronic properties. The conductivity and transparency of these films are found to be strongly dependent on their chemical composition and the substrate temperature during growth. The conductivity of BaCu2S2 and BaCu4S3 can reach 53 S/cm (at 250 degrees C) and 74 S/cm (at 200 degrees C), respectively, which is higher than their solution processed/bulk counterparts. The 90% reflectance corrected transmittance is achieved in the wavelength range 600-1000 nm for BaCu2S2 and 650-1000 nm for BaCu4S3 (at 250 degrees C). These electrical optical properties are comparable with other recently presented transparent p-type conductors, while the 200-350 degrees C processing temperature is low enough to be used in semiconductor devices with limited thermal budgets. Attempts have been made to synthesize the related Sr-Cu-S materials, following the theoretical suggestion of their potential as transparent p-type conductors, but these attempts resulted only in phase-separated SrS and CuxS phases. Alloying BaCu2S2 with Sr on the Ba site on the other hand increases the conductivity to >100 S/cm while only slightly compromising the transparency of the material. To explain the difference between the Ba and the Sr containing copper sulfides, the lower bounds on the SrCu2S2 and SrCu4S3 formation enthalpies are estimated. While the doping of the Ba-Cu-S materials presented here is too large for application in transparent electronics, it is promising for potential use as p-type contact layers in thin film solar cells.

Perovskite Ba(Sr)SnO3: Promising Transparent Conducting Oxides

Designing Optically Transparent and Electrically Conducting BaSnO3 and SrSnO3 Perovskite Oxide Compounds Using First-Principles Calculations

Origin of the Superior Conductivity of Perovskite Ba(Sr)SnO3

High Optical Transmittance and Anomalous Electronic Transport in Flexible Transparent Conducting Oxides Ba0.96La0.04SnO3 Thin Films

Transparent and Conductive Oxide Films with the Perovskite Structure: La- and Sb-Doped Basno3

Design of ternary alkaline-earth metal Sn(II) oxides with potential good p-type conductivity

Transparent and conductive oxide films of the perovskite La xSr1-xSnO3 (x ≤ 0.15): Epitaxial growth and application for transparent heterostructures

Solution Processing of Transparent Conducting Epitaxial La:Basno3 Films with Improved Electrical Mobility

Single-Crystalline Transparent and Conductive Oxide Films with the Perovskite Structure: Sb-Doped Srsno3

Transparent and conductive oxide films of the perovskite La<sub><i>x</i></sub>Sr<sub>1−<i>x</i></sub>SnO<sub>3</sub>(<i>x</i>⩽ 0.15): epitaxial growth and application for transparent heterostructures

Structural, electrical, and optical properties of R x Ba 1− x SnO 3 ( R = La, Nd, Sm, Er) transparent thin films

Physical properties of transparent perovskite oxides (Ba,La)SnO3 with high electrical mobility at room temperature

Tuning Optical Properties of Transparent Conducting Barium Stannate by Dimensional Reduction

Ultrasmall Blueshift of Near-Infrared Fluorescence in Phase-Stable Cs2SnI6 Thin Films

Structure-Composition-Property Relationships in Antiperovskite Nitrides: Guiding a Rational Alloy Design.

Composition Dependent Intrinsic Defect Structures in ASnO3 (A = Ca, Sr, Ba)

Phonon-assisted optical absorption in BaSnO$_3$ from first principles

Oxide perovskite BaSnO3: A promising high-temperature thermoelectric material for transparent conducting oxides

Pitfalls and solutions for perovskite transparent conductors

Electronic Structure and Anion Engineering for Perovskite Oxysulfide BaTi(O,S)3

Optoelectronic Properties of Strontium and Barium Copper Sulfides Prepared by Combinatorial Sputtering