Abstract:Optically transparent materials with p-type electrical conductivity can facilitate the development of transparent electronics and improve the efficiency of photovoltaic solar cells. Sulfide materials represent an interesting alternative to oxides for these applications due to better hole transport properties. Here, transparent and conductive Ba-Cu-S thin films are prepared by combinatorial cosputtering and characterized for their composition, structure, and optoelectronic properties. The conductivity and transparency of these films are found to be strongly dependent on their chemical composition and the substrate temperature during growth. The conductivity of BaCu2S2 and BaCu4S3 can reach 53 S/cm (at 250 degrees C) and 74 S/cm (at 200 degrees C), respectively, which is higher than their solution processed/bulk counterparts. The 90% reflectance corrected transmittance is achieved in the wavelength range 600-1000 nm for BaCu2S2 and 650-1000 nm for BaCu4S3 (at 250 degrees C). These electrical optical properties are comparable with other recently presented transparent p-type conductors, while the 200-350 degrees C processing temperature is low enough to be used in semiconductor devices with limited thermal budgets. Attempts have been made to synthesize the related Sr-Cu-S materials, following the theoretical suggestion of their potential as transparent p-type conductors, but these attempts resulted only in phase-separated SrS and CuxS phases. Alloying BaCu2S2 with Sr on the Ba site on the other hand increases the conductivity to >100 S/cm while only slightly compromising the transparency of the material. To explain the difference between the Ba and the Sr containing copper sulfides, the lower bounds on the SrCu2S2 and SrCu4S3 formation enthalpies are estimated. While the doping of the Ba-Cu-S materials presented here is too large for application in transparent electronics, it is promising for potential use as p-type contact layers in thin film solar cells.

Copper‐alloyed ZnS As a P‐type Transparent Conducting Material

Characterisation of p-type ZnS:Cu transparent conducting films fabricated by high-temperature pulsed laser deposition

P-Type Transparent Conductor: Zn-doped CuAlS2

P-type Transparent Conducting Copper Aluminum Oxide Films with Different Cu/Al Ratio

Zn-Doped Cuals(2) Transparent P-Type Conductive Thin Films Deposited By Pulsed Plasma Deposition

Alloying ZnS in the hexagonal phase to create high-performing transparent conducting materials

Transparent and conducting p-type (CuS) x :(ZnS) 1-x thin films produced by thermal Evaporation: An efficient broadband Si heterojunction photodiode

Growth and Properties of P-Type Zn-Doped CuAlS_2 Films

Optoelectronic Properties of Strontium and Barium Copper Sulfides Prepared by Combinatorial Sputtering

Cs‐Doped and Cs‐S Co‐Doped CuI p‐Type Transparent Semiconductors with Enhanced Conductivity

Synthesis and Characterization of Hydrazine Solution Processed Cu12Sb4S13 Film

New energy with ZnS: novel applications for a standard transparent compound

Copper(i) Sulfide: a Two-Dimensional Semiconductor with Superior Oxidation Resistance and High Carrier Mobility.

Amorphous Transparent Cu(S,I) Thin Films with Very High Hole Conductivity

Activating P-Type Conduction and Visible Transparency in Delafossite CuAlO2 Films: the Critical Role of the Copper Valence State Transition

Highly Conductive p-Type Transparent Conducting Electrode with Sulfur-Doped Copper Iodide

Electrical characterization of Cu-doped CdS p-type thin film transistors

P -Type Conduction in N–Al Co-Doped ZnO Thin Films

First-Principles Study of Cu9S5: A Novel P-Type Conductive Semiconductor

Improving the p–type conductivity of Cu2O thin films by Ni doping and their heterojunction with n–ZnO

Solution-processed amorphous p-type Cu-Sn-I thin films for transparent Cu-Sn-I/IGZO p–n junctions