A High Counting-Rate Readout ASIC for CZT Detectors
Siyao Zhao,Chaosong Gao,Xiaojuan Tian,Qiaomu Tong,Lirong Xie,Ming Yang,Hongbang Liu,Xiangming Sun
DOI: https://doi.org/10.1016/j.nima.2024.169416
IF: 1.335
2024-01-01
Nuclear Instruments and Methods in Physics Research Section A Accelerators Spectrometers Detectors and Associated Equipment
Abstract:Photon-Counting-Detector-Computed-Tomography (PCD-CT) is a promising new technique for Computed Tomography (CT) imaging. Compared to traditional Energy-Integrating-Detector (EID) CT systems, PCD-CT allows for more refined image reconstruction and lower radiation doses due to its higher energy resolution. Typically, Cadmium Zinc Telluride (CZT) hybrid-pixel detectors are used for PCD-CT. The Application Specific Integrated Circuit(ASIC), used in CZT hybrid pixel detectors, must feature a high counting rate to prevent signal pile−up.An ASIC named Topmetal-PCD for CZT hybrid pixel detectors has been designed in a TSMC 180 nm BCD process, featuring a three-side buttable matrix of 20 × 100 pixels with a pitch of 150μm. Each pixel is composed of an exposed top-most metal, a Charge Sensitive Preamplifier (CSA), a Peak Detecting and Holding circuit (PDH), two source followers (SFs), three comparators, and three 12-bit counters. The pixel array is read out through a rolling shutter scheme with a maximum frame rate of up to 1 × 104 frame per second (fps). In this paper, only post-layout simulation results are presented. The post-layout simulation results indicate that the analog front end features a gain of ∼ 60 mV/fC and an input Equivalent Noise Charge (ENC) of 310 e−. The chip can handle a maximum flux of ∼ 2 × 108 counts per second per square millimeter (cps/mm2) under detector capacitances of less than 100 fF, while the power consumption of the single pixel is as low as 80 μW under the power supply of 1.8 V. Furthermore, the ASIC also includes an analog readout channel that can directly transmit the signal waveform off the chip.