Abstract:A multi-purpose readout electronics based on the DPLMS digital filter has been developed for CdTe and CZT detectors for X-ray imaging applications. Different filter coefficients can be synthesized optimized either for high energy resolution at relatively low counting rate or for high rate photon-counting with reduced energy resolution. The effects of signal width constraints, sampling rate and length were numerical studied by Mento Carlo simulation with simple CRRC shaper input signals. The signal width constraint had minor effect and the ENC was only increased by 6.5% when the signal width was shortened down to 2 τc. The sampling rate and length depended on the characteristic time constants of both input and output signals. For simple CR-RC input signals, the minimum number of the filter coefficients was 12 with 10% increase in ENC when the output time constant was close to the input shaping time. A prototype readout electronics was developed for demonstration, using a previously designed analog front ASIC and a commercial ADC card. Two different DPLMS filters were successfully synthesized and applied for high resolution and high counting rate applications respectively. The readout electronics was also tested with a linear array CdTe detector. The energy resolutions of Am-241 59.5 keV peak were measured to be 6.41% in FWHM for the high resolution filter and to be 13.58% in FWHM for the high counting rate filter with 160 ns signal width constraint.

Performance Optimization of Pixelated CdZnTe Detector Readout by Analog ASIC Using Cathode Waveform

Improvement of Count Rate for Pixelated CdZnTe Detector Array

Development of a Pixel Readout ASIC for CZT Detectors for Spectral X-ray Photon-Counting Imaging Applications

Design and test results of a low-noise readout ASIC for pixelated CdZnTe detectors

Development Of A Low Noise Readout Asic For Czt Detectors For Gamma-Ray Spectroscopy Applications

Development Of A Multi-Energy Photon-Counting Readout Asic For Czt Detectors

Charge-sensitive front-end electronics with operational amplifiers for CdZnTe detectors

Design of A Low Noise Readout Asic for Cdznte Detector

Performance investigations of two channel readout configurations on the cross-strip cadmium zinc telluride detector

A Low Noise Readout Asic for Cdte/Cdznte Detectors

Signal Processing Of A Strengthened Electric Field Line Anode Cdznte Detector

An Energy and Time Measurement ASIC for Large Pixel Semiconductor Detectors for Spectroscopic and Imaging Applications

Identification of Single-Pixel Incomplete Charge Collection Events by Using Cathode Waveform in Pixelated CdZnTe Detectors

Fabrication and Test of Pixelated CZT Detectors with Different Pixel Pitches and Thicknesses

Experimental Characterization of an X-ray Photon Counting Detector

A Highly Linear FPGA-Based TDC and a Low-Power Multichannel Readout ASIC with a Shared SAR ADC for SiPM Detectors

Readout Electronics Development Based on an ASIC for PET Detector Using PMT-quadrant-sharing

Development of a Simultaneous Photon Counting and Energy Integrating Readout ASIC for X-ray Imaging Applications

A Multi-Purpose Readout Electronics for CdTe and CZT Detectors for X-Ray Imaging Applications

Test measurements of an ASIC for X-ray material discrimination by using on-chip time domain integration and a CdTe sensor

Development of a Low Power and High Integration Readout ASIC for Time Projection Chambers in 65 Nm CMOS