Abstract:New time-based readout (TBR) electronics has been developed and evaluated for its performance and application for PET detectors. It consists of a leading edge (LE) timing threshold for timing pickoff that provides a signal timing t1; a charge integration followed by a constant discharge between two specific timings t2 and t3 that are used to directly measure the signal energy. The timing-walk error caused by LE from signals of different amplitudes can be measured with t1 as a function of different signal amplitudes that is proportional to the time difference between t2 and t3. With this pre-calibration, timing-walk error can be accurately corrected. Therefore, both signal timing and energy can be accurately measured with digital timing signals without using CFD and ADC. These timing signals were controlled and in principle can be measured by an FPGA that can apply many signal logic and data correction algorithms. A single channel discrete component TBR circuit has been implemented in PC board, and 8-channel ASIC chips have been developed for feasibility evaluations and PET detector applications. Initial functionality and performance evaluations have been conducted. Signal amplitude measurement accuracy and linearity are very good; the measured timing accuracy from a pulse is the same as a standard CFD and reaches to similar to 100 ps resolution with the test setup. Both suitable energy and coincidence timing resolutions (similar to 17% and similar to 1.0-2.0 ns) were achieved with PMT or Solid-State PM (SSPM) array based PET detectors. Initial studies to acquire flood source crystal identification map has demonstrated the advantages of applying parallel readout with TBR electronics that read out and process signals from each pixel of SSPM array independently. With its relatively simple circuit and low cost, TBR electronics is expected to provide suitable front-end signal readout electronics for compact photon detectors such as SSPM array that require large number of output channels and demand high performance in energy and timing.

Readout Electronics Development Based on an ASIC for PET Detector Using PMT-quadrant-sharing

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

A Design Implementation of the Central Process Module for an In-Beam PET in HICTD

Development Of Multi-Channel Fast Sipm Readout Electronics For Clinical Tof Pet Detector

Development of an Eight-Channel Time-Based Readout Asic for Pet Applications

Development of a 64-Channel Readout ASIC for an ${8 \times 8}$ SSPM Array for PET and TOF-PET Applications

PETAT -- An ASIC for Simple and Efficient Readout of Large PET Scanners

Design And Initial Performance Evaluation Of A Novel Pet Detector Module Based On Compact Sipm Arrays

Development of a 64-Channel Readout ASIC for an SSPM Array for PET and TOF-PET Applications

Design and evaluation of a FPGA-ADC prototype for the PET detector based on LYSO Crystals and SiPM arrays

Development of a Multi-Channel ASIC with Individual Energy and Timing Digitization for SiPM Detectors for TOF-PET Applications

Development of a Compact DOI–TOF Detector Module for High-Performance PET Systems

A multi-functional front end readout electronics system for PET detector application

A compact and highly integrated 128-channel FPGA-based readout electronics for nuclear imaging application

Energy And Timing Measurement Of A Pet Detector With Time-Based Readout Electronics

Design And Development Of Novel And Practical Pet Detectors For Advanced Imaging Applications

Development of a MR-compatible DOI-TOF detector module for PET imaging systems

Optimization of Dual Mode Readout of Sensl SiPM for TOF PET Detectors

Development Of A Multi-Energy Photon-Counting Readout Asic For Czt Detectors

A Novel Sub-Millimeter Resolution Pet Detector with Tof Capability

Inexpensive Position Sensitive Detector Block for 40 Mm Diameter PMT Using Quadrant Sharing Configuration