Abstract:Silicon photomultipliers (SiPMs) are highly valued for their excellent light response and high gain characteristics, yet their application in fast timing scenarios is often limited by their high terminal capacitance, typically over 300 pF. In electromagnetic calorimeters, sub-nanosecond time measurements allow these detectors to function as supplementary time-of-flight devices, specifically aiming for a time resolution of 150 ps in the NICA-MPD. To address these challenges, this study proposes a novel front-end readout electronics design featuring a two-stage common-base transimpedance preamplifier and a 12-bit 200 MS/s pipelined successive-approximation-register (SAR) analog-to-digital converter (ADC). Extensive SPICE simulations, using the Hamamatsu S13360-6025 as the input source, demonstrate the preamplifier’s rapid rise time and good linearity. Experimental results from laser testing confirm that this fast preamplifier design achieves a remarkable time resolution of better than 20 ps. The ADC circuit, designed using the TSMC65nmLP process, employs a two-stage pipelined SAR structure with a two-step conversion technique (6-bit + 7-bit), incorporating redundancy in the second step. Testing at a 160MHz sampling rate with an 80MHz input condition showed that, at Vpk = -1dBFS, the ADC’s FFT spectrum analysis yielded an effective number of bits (ENOB) of 9.34 and a spurious-free dynamic range (SFDR) of 73.8 dBc. Preliminary System-level timing assessments under a 200 MHz sampling rate revealed that waveforms with 3 to 4 sampling points on the rising edge, with a rise time of 15 to 20 ns, achieved a time resolution of approximately 20 ps.

Casca: A Readout Asic For A Tpc Based X-Ray Polarimeter

The Development of a Readout ASIC for TPC Based X-ray Polarimeter

Radiation Characterization of A Switched Capacitor Array Readout Asic for Time Projection Chamber

Development of a Low Power and High Integration Readout ASIC for Time Projection Chambers in 65 Nm CMOS

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

Development Of A Multi-Energy Photon-Counting Readout Asic For Czt Detectors

Casagem: A Readout Asic for Mpgds

A Mixed-Signal Micromegas Readout ASIC Prototype With Automatic Charge Measurement Range Calibration

Development of a Pixel Readout ASIC for CZT Detectors for Spectral X-ray Photon-Counting Imaging Applications

Beam Test of a Monolithic Active Pixel Sensor for the CEPC Vertex Detector

Development of A Multi-Channel Readout Asic for A Fast Neutron Spectrometer Based on Gem-Tpc

An Energy and Time Measurement ASIC for Large Pixel Semiconductor Detectors for Spectroscopic and Imaging Applications

Data Acquisition System for CEPC Vertex Detector Prototype

Experimental Characterization of an X-ray Photon Counting Detector

The SparkPix-S ASIC for the sparsified readout of 1 MHz frame-rate X-ray cameras at LCLS-II: pixel design and simulation results

Development of a Simultaneous Photon Counting and Energy Integrating Readout ASIC for X-ray Imaging Applications

Development Of A Low Noise Readout Asic For Czt Detectors For Gamma-Ray Spectroscopy Applications

An Analogue Front-End ASIC Prototype Designed For PMT Signal Readout

A Fast Front-end Readout Design for NICA-MPD Shashlik Electromagnetic Calorimeter

Readout Electronics Development Based on an ASIC for PET Detector Using PMT-quadrant-sharing

A multichannel front end ASIC for PMT readout in LHAASO WCDA