The SparkPix-S ASIC for the sparsified readout of 1 MHz frame-rate X-ray cameras at LCLS-II: pixel design and simulation results

L. Rota,F. Mele,A. Habib,H. Kim,P. King,B. Markovic,A. Peña Perez,A. Dragone

DOI: https://doi.org/10.1088/1748-0221/19/01/c01010

2024-01-17

Journal of Instrumentation

Abstract:Exploiting the "sparse" nature of the information in XPCS (X-ray Photon Correlation Spectroscopy) and XSVS (Speckle Visibility Spectroscopy) experiments, we present the SparkPix-S, a 3-sides buttable Application Specific Integrated Circuit (ASIC) based on a sparsified readout strategy for large-format hybrid detectors. The SparkPix-S architecture, based on the successful ePix family, will be composed as follows: a front-end 2-D matrix of 384×352 square pixels with 50 μm pitch is arranged to match the dimensions of a PIN Si-sensor matrix; charge readout, signal shaping and amplitude discrimination is performed at pixel-level, by means of a low-power (<18 μW) analog processor, which, in case of an event, negotiates access to an analog bus placed every other column; on the chip periphery (balcony), the information on each bus is digitized by an array of successive approximation analog-to-digital converters (SAR-ADCs) running at 10 Msps; on the digital back-end the global logic will generate the output data stream using low-voltage differential signalling (LVDS). A first prototype of the SparkPix-S, with a reduced matrix size of 96×96 pixels, is currently under production on a 130 nm CMOS technology. Simulated performance results show an equivalent noise charge <60 el. r.m.s. at 1 MHz repetition rate, with a maximum input energy of 60 keV and capability to discriminate charge signals with equivalent energy as low as 900 eV.

instruments & instrumentation

What problem does this paper attempt to address?

This paper aims to solve the problem of large - scale data readout of X - ray cameras at a high frame rate (1 MHz) during XPCS (X - ray Photon Correlation Spectroscopy) and XSVS (Speckle Visibility Spectroscopy) experiments on LCLS - II (Linac Coherent Light Source II). Specifically, these experiments require a new generation of two - dimensional detectors with fine spatial resolution (<50 μm), capable of single - photon resolution in the soft X - ray and medium - energy X - ray ranges, and able to operate at the full 1 MHz repetition rate of LCLS - II. However, for a 1 - million - pixel camera, if full - frame readout is carried out at a frame rate of 1 MHz, the expected data throughput will reach several TB/s, which poses a huge challenge to data processing and analysis capabilities.

To meet this challenge, the paper introduces SparkPix - S, an application - specific integrated circuit (ASIC) based on a sparse readout strategy for large - scale hybrid detectors. By taking advantage of the information sparsity in XPCS and XSVS experiments (that is, the average occupancy per frame is about 0.05%, and the occupancy in a single exposure is still far below 1%), SparkPix - S has designed a three - side - stitchable ASIC, which can significantly reduce the data rate from several TB/s to dozens of GB/s. At the same time, SparkPix - S also has low - noise characteristics and can effectively distinguish a small fraction of photon signals, which is especially important for the charge - sharing effect caused by small - size pixels.

The paper elaborately describes the architecture design of SparkPix - S, the pixel readout architecture, the physical layout of the prototype, and the simulation results, and shows its performance at a 1 MHz repetition rate, including capabilities in terms of equivalent noise charge (<60 electrons rms), maximum input energy (60 keV), and minimum detectable signal (900 eV).