Abstract:A digital deconvolution method with pile-up reconstruction has been proposed for scintillator detectors for high rate photon-counting X-ray imaging applications. The detector signal was modeled as an exponential decay waveform convoluted with the single photon response of the SiPM detector. An impulse signal can be obtained by digital deconvolution (unfolding) with much shorter duration, which was then used for energy estimation followed by a trapezoid filter and pile-up discrimination The whole digital deconvolution algorithm has been synthesized and verified by both SIMULINK simulation and experimental tests. The prototype of the detector and the readout electronics were developed for demonstration, using 3 mm x 3 mm x 10 mm LYSO scintillator coupled with a 3 mm x 3 mm SenSL SiPM. A 14 bit, 100 MSPS ADC was used to sample the analog waveform and the digital filter was implemented in a Xilinx Kintex 7 FPGA. The signal width was shortened from similar to 250 ns to 10 similar to 20 ns and then was shaped into trapezoidal pulse with 100 ns width. The energy was estimated from the trapezoid top for better signal collection and noise rejection. The unfolded pulses were used for pile-up discrimination and to reconstruct two pile-up signals from the overlapped trapezoid outputs. The energy performance of the prototype system was firstly validated by measuring the energy spectrums of Am-241, Co-57, Na-22 and Cs-137 radiation sources. The energy resolutions were measured to be 36.9%, 29.9%, 13.9% and 12.9% respectively at 59.5 keV, 122 keV, 511 keV and 662 keV in FWHM. High rate performance was evaluated by an X-ray generator. The maximum output counting rate was measured to 5.36 Mcps without saturation, comparing with the saturated counting rate of 2.34 Mcps using the original LYSO signals The saturation counting rate using digital deconvolution was estimated to be up to similar to 7 Mcps fitted with the paralyzable dead time model, corresponding to similar to 20 Mcps input count rate.

Progress on a Simultaneous Photon Counting and Energy Integrating Detector for X-ray Imaging Applications

Development of a Simultaneous Photon Counting and Energy Integrating Readout ASIC for X-ray Imaging Applications

Experimental characterization of asimultaneous photoncounting and energy integrating detector for X-ray imaging applications

Photon Counting Correction Method to Improve the Quality of Reconstructed Images in Single Photon Compressive Imaging Systems.

Multi-channel Weak Current Acquisition System for X-ray Sensor

CIX - A Detector for Spectral Enhanced X-ray Imaging by Simultaneous Counting and Integrating

Experimental Characterization of an X-ray Photon Counting Detector

Development Of A Multi-Energy Photon-Counting Readout Asic For Czt Detectors

Digital Deconvolution Of Scintillation Detector Signals For High Rate Photon-Counting X-Ray Imaging Applications

Chromatic X-Ray imaging with a fine pitch CdTe sensor coupled to a large area photon counting pixel ASIC

Material Discrimination Study of Dual-Energy Imaging Using Photon Counting Detector

Physical Design of Photon-Counting Mode Γ-Ray Large Object Radiation Imaging System.

Preliminary CT Results Using a Simultaneous Photon-Counting and Energy-Integrating Prototype Detector

Development of a single-photon-counting camera with use of a triple-stacked micro-channel plate

An Energy and Time Measurement ASIC for Large Pixel Semiconductor Detectors for Spectroscopic and Imaging Applications

Development of a single-photon imaging detector with pixelated anode and integrated digital read-out

Dual-energy micro-CT with a dual-layer, dual-color, single-crystal scintillator

Design and Optimization of Direct-Conversion Photon-Counting Detector for Dual-Energy Ct Imaging

First Experimental Evaluation of a High-Resolution Deep Silicon Photon-Counting Sensor

Simultaneous X-Ray Fluorescence and K-edge CT Imaging with Photon-Counting Detectors

Multi-energy X-ray linear-array detector enabled by the side-illuminated metal halide scintillator