Abstract:Autothermal reforming (ATR) of methane is a promising technology for low-carbon H2 production due to its high CO2 capture efficiency (>95 %) and cost advantage. Especially, reforming CO2+CH4 greenhouse gases to valuable CO+H2 gases is a feasible solution for carbon-neutral energy systems. Flame temperature, reforming gas composition and concentration, and soot loading are major factors determining the efficiency of H2 production in the subsequent catalyst region. In this study, the effects of CO2/CH4 ratio on the profiles of temperature, OH radical, light gas products, large polycyclic aromatic hydrocarbons (PAHs), and soot were investigated for CH4-CO2-O2 laminar inverse diffusion flames near ATR conditions, using the combined non-intrusive and intrusive diagnostic methods. Pure O2 as oxidizer was fed through the central nozzle of the burner surrounded by CH4 fuel diluted with CO2. The experimental results revealed that the formation of soot and PAHs was greatly suppressed with a higher CO2/CH4 ratio. The PAHs and soot loading followed exponential function as CO2/CH4 mole ratio, regardless of pressure, O2 mole fraction, and burner size. The flame height was found to increase linearly with CO2 dilution, and the high temperature region (> 1000 K) shifts downstream. The H2 production decreased with CO2/CH4 ratio, while CO production is less sensitive to CO2 dilution. The importance of radical species during soot formation is confirmed based on the comprehensive data set. Moreover, five well-known chemical-kinetic mechanisms were evaluated against experimental datasets. The comparisons indicate that the flame temperature and concentration trends of investigated species are well predicted, but future work is needed to improve the prediction accuracy of amplitude and spatial distribution, especially for C2H2, PAHs and soot. The reported experiment and simulation results can provide valuable guidance for ATR model validation, development, reduction, and application.

Experimental Study on Wall Temperature Distribution Characteristics and Control Methods of Wall Temperature Uniformity in Tail Gas Catalytic Combustion

Experimental study of hydrogen catalytic combustion wall temperature distribution characteristics and its effect on the coupling performance of autothermal reformers

Heat Sink and Conversion of Catalytic Steam Reforming for Hydrocarbon Fuel

Characterization of CH4-CO2-O2 Diffusion Flames Near Autothermal Reforming Condition

Experimental investigation on the temperature characteristics and hydrogen elimination effect of non-premixed hydrogen-oxygen recombination reaction at ambient temperature

Topology optimization of the catalyst distribution of planar methane steam reformers

Thermal matching characteristics in an autothermal methanol reforming microchannel reactor for hydrogen production

Numerical Simulation of Enhanced Heat Transfer in Tubes Using Methane Steam Reforming

Experimental study of premixed n-heptane/air catalytic combustion characteristics in micro-cylindrical tube

Experimental Study of the Design and Performance Optimisation of a Self-Heating Methanol On-Board Reforming Reactor for Hydrogen Production

Coordinated Optimization Control of Flue Gas Temperature for Improving Reaction Efficiency of Catalyst

Tri-reforming of methane to syngas over Ni/Al2O3 — Thermal distribution in the catalyst bed

Effect Analysis of Heating Direction and Catalyst Coating Thickness on CH4-H2O Reforming in Microreactors

Cooling and coke deposition of hydrocarbon fuel with catalytic steam reforming

Characteristic Investigation on the Methanol Steam Reforming Microchannel Reactor with the Novel Catalytic Combustion Self-Heating Structure for Hydrogen Production

Experimental Investigations and Numerical Simulation of Thermo-Catalytic Reforming Ammonia for Hydrogen Production

Simulation and enhancement of axial temperature distribution in a reactor filled with in-situ electrically heated structured catalyst

Design and Performance Investigation of a Compact Catalytic Reactor Integrated with Heat Recuperator

Combustion of hydrogen–air in catalytic micro-combustors made of different material

Numerical simulation on flow and reaction characteristics for catalytic region in helium-heated steam reformer coupled with HTR-10

Effect of Thermal Property of Materials on Micro-scale Catalytic Combustion for the Micro Combustor