Abstract:High-resolution active-matrix organic light-emitting diode (AMOLED) thin-film transistor (TFT) backplane with lower power consumption is needed for augmented reality (AR) applications. The near-to-eye format of AR terminals needs facing several technical challenges, such as higher optical efficiency, wider field of view, lighter weight, and smaller size to accelerate widespread applications. For these reasons, downscaling of TFTs with amorphous-indium-gallium-zinc-oxide (a-IGZO) or LTPS is required. The channel length should be less than 1 μm and the flexible substrate is better than glass because of light weight and very thin structure. TFT technologies on polyimide (PI) substrate can support the applications for foldable and rollable displays. For flexible AMOLED, PI layer of 10 to 20 um is widely used for foldable displays. The PI layer is coated by slot coating on the top of a carrier glass with a buffer layer of carbon nanotubes (CNTs) and graphene oxide (GO) mixture coated by spray. This layer can reduce the adhesion force between PI and glass and thus mechanical detachment can be possible. The CNTs are conducting so that it can release the electrostatic discharge (ESD) damage because CNTs/GO layer exists on the bottom side of the PI substrate. The PI substrate is covered by SiO 2 and ZrAlO x layers (five layers in total starting with SiO 2 ) by plasma enhanced chemical vapor deposition and spray pyrolysis, respectively, which acts as a gas barrier. The amorphous ZrAlO x film by spray coating can be used as a high-k gate insulator and also a gas barrier. The threshold voltage of a-IGZO TFTs tends to shift toward negative gate voltage with decreasing the channel length. In this work, a ZrAlO x passivation layer is introduced for the short channel, coplanar a-IGZO TFT. A very thin ZrAlO x layer is deposited by spray pyrolysis on the top of a-IGZO TFT at the substrate temperature of 350 °C before interlayer deposition. The a-IGZO TFT with a very thin ZrAlO x layer exhibits the stable threshold voltage dependence with decreasing the channel length. The 0.8 μm channel length a-IGZO TFT with ZrAlO x layer by spray pyrolysis at the substrate temperature of 350 °C exhibits the field-effect mobility of 7.09 cm 2 V -1 s -1 , the threshold voltage of -0.6 V, and on/off current ratio of 3.3 × 10 7 . The formation of Zr-O bonds on the a-IGZO surface region reduces the carrier concentration in the a-IGZO TFT offset region, between source/drain contact and the channel, and blocks the carrier diffusion into the channel. This is the first reported self-aligned coplanar a-IGZO TFT under 1 μm channel length on a flexible substrate. Figure 1

Al Reaction-Induced Conductive A-Ingazno As Pixel Electrode for Active-Matrix Quantum-Dot LED Displays

Amorphous In–Ga–Zn–O Thin Film Transistor Current-Scaling Pixel Electrode Circuit for Active-Matrix Organic Light-Emitting Displays

Full-color Quantum Dots Active Matrix Display Fabricated by Ink-Jet Printing

(Invited) Short Channel Coplanar Amorphous-Indium-Gallium-Zinc-Oxide Thin-Film Transistors on Polyimide Substrate for High Resolution Displays

High-performance IGZO-based TFTs with Stacked Al<sub>2</sub>O<sub>3</sub>/HfO<sub>2</sub> Dielectrics

A Back-Channel-Etched Amorphous InGaZnO Thin-Film Transistor Technology with Al-Doped ZnO As Source/Drain and Pixel Electrodes

Comparative Study of Atomic Layer Deposited Indium-Based Oxide Transistors with a Fermi Energy Level-Engineered Heterojunction Structure Channel through a Cation Combinatorial Approach

Inkjet-Printed Oxide Thin-Film Transistors Based on Nanopore-Free Aqueous-Processed Dielectric for Active-Matrix Quantum-Dot Light-Emitting Diode Displays

Inkjet-Printed Oxide Thin-Film Transistors Based on Nanopore-Free Aqueous-Processed Dielectric for Active-Matrix Quantum-Dot Light-Emitting Diodes Displays.

High-Performance Fully Thermal ALD-Processed IGZO Thin Film Transistors

Back-Channel-Etched IGZO TFTs With Cu-Based Multilayer Electrodes Using MoAl Alloy and MoMn Alloy as Buffer Layers

High-Performance Amorphous InGaZnO Thin-Film Transistor Gated by HfAlOₓ Dielectric with Ultralow Subthreshold Swing

AgNWs/AZO composite electrode for transparent inverted ZnCdSeS/ZnS quantum dot light-emitting diodes

A full high‐definition quantum dot light‐emitting diode‐on‐silicon microdisplay

Amorphous IGZO TFT with High Mobility of ~70 cm2/Vs via Vertical Dimension Control using PEALD.

Metal Reaction-Induced Bulk-Doping Effect in Forming Conductive Source-Drain Regions of Self-Aligned Top-Gate Amorphous InGaZnO Thin-Film Transistors.

High-Performance Indium-Gallium-Zinc-Oxide Thin-Film Transistors with Stacked Al<sub>2</sub>O<sub>3</sub>/HfO<sub>2</sub> Dielectrics

Evolution of Enhanced Performance of a-IGZO TFTs With Cu/Al-Based Contacts

Excellent Uniformity and Reliability Top‐Gate Self‐Aligned IGZO TFTs with Cu Electrode

Progress in the Development of Active-Matrix Quantum-Dot Light-Emitting Diodes Driven by Non-Si Thin-Film Transistors

Thin Film Transistor Using Amorphous InGaZnO Films as Both Channel and Source/Drain Electrodes