Abstract:High-resolution active-matrix organic light-emitting diode (AMOLED) thin-film transistor (TFT) backplane with lower power consumption is needed for augmented reality (AR) applications. The near-to-eye format of AR terminals needs facing several technical challenges, such as higher optical efficiency, wider field of view, lighter weight, and smaller size to accelerate widespread applications. For these reasons, downscaling of TFTs with amorphous-indium-gallium-zinc-oxide (a-IGZO) or LTPS is required. The channel length should be less than 1 μm and the flexible substrate is better than glass because of light weight and very thin structure. TFT technologies on polyimide (PI) substrate can support the applications for foldable and rollable displays. For flexible AMOLED, PI layer of 10 to 20 um is widely used for foldable displays. The PI layer is coated by slot coating on the top of a carrier glass with a buffer layer of carbon nanotubes (CNTs) and graphene oxide (GO) mixture coated by spray. This layer can reduce the adhesion force between PI and glass and thus mechanical detachment can be possible. The CNTs are conducting so that it can release the electrostatic discharge (ESD) damage because CNTs/GO layer exists on the bottom side of the PI substrate. The PI substrate is covered by SiO 2 and ZrAlO x layers (five layers in total starting with SiO 2 ) by plasma enhanced chemical vapor deposition and spray pyrolysis, respectively, which acts as a gas barrier. The amorphous ZrAlO x film by spray coating can be used as a high-k gate insulator and also a gas barrier. The threshold voltage of a-IGZO TFTs tends to shift toward negative gate voltage with decreasing the channel length. In this work, a ZrAlO x passivation layer is introduced for the short channel, coplanar a-IGZO TFT. A very thin ZrAlO x layer is deposited by spray pyrolysis on the top of a-IGZO TFT at the substrate temperature of 350 °C before interlayer deposition. The a-IGZO TFT with a very thin ZrAlO x layer exhibits the stable threshold voltage dependence with decreasing the channel length. The 0.8 μm channel length a-IGZO TFT with ZrAlO x layer by spray pyrolysis at the substrate temperature of 350 °C exhibits the field-effect mobility of 7.09 cm 2 V -1 s -1 , the threshold voltage of -0.6 V, and on/off current ratio of 3.3 × 10 7 . The formation of Zr-O bonds on the a-IGZO surface region reduces the carrier concentration in the a-IGZO TFT offset region, between source/drain contact and the channel, and blocks the carrier diffusion into the channel. This is the first reported self-aligned coplanar a-IGZO TFT under 1 μm channel length on a flexible substrate. Figure 1

Thin Film Transistor Using Amorphous InGaZnO Films as Both Channel and Source/Drain Electrodes

Self-Assembled Transparent A-Igzo Based Tfts for Flexible Sensing Applications

Present status of amorphous In–Ga–Zn–O thin-film transistors

Enhanced Performance of A-Igzo Thin-Film Transistors by Forming AZO/IGZO Heterojunction Source/drain Contacts

Fabrication and Properties of InGaZnO Thin-Film Transistors Based on a Sol–Gel Method with Different Electrode Patterns

Amorphous IZO-based transparent thin film transistors

A Back-Channel-Etched Amorphous InGaZnO Thin-Film Transistor Technology with Al-Doped ZnO As Source/Drain and Pixel Electrodes

Amorphous InGaZnO Thin Film Transistors with Different Transparent Electrodes

Performance Enhancement of Channel-Engineered Al-Zn-Sn-O Thin-Film Transistors with Highly Conductive In-Ga-Zn-O Buried Layer via Vacuum Rapid Thermal Annealing

Tri‐Layer Heterostructure Channel of a‐IGZO/a‐ITZO/a‐IGZO Toward Enhancement of Transport and Reliability in Amorphous Oxide Semiconductor Thin Film Transistors

(Invited) Short Channel Coplanar Amorphous-Indium-Gallium-Zinc-Oxide Thin-Film Transistors on Polyimide Substrate for High Resolution Displays

Amorphous In-Ga-Zn-O Thin-Film Transistors Fabricated by Microcontact Printing

High performance, transparent a-IGZO TFTs on a flexible thin glass substrate

Amorphous InGaZnO Thin Film Transistors with Wet-Etched Ag Electrodes

Effect of high conductivity amorphous InGaZnO active layer on the field effect mobility improvement of thin film transistors

Transparent Amorphous Indium-Gallium-Zinc-Oxygen Thin Film Transistors Using Solution Technology at Low Temperature

High-Performance Amorphous InGaZnO Thin-Film Transistor Gated by HfAlOₓ Dielectric with Ultralow Subthreshold Swing

Highly Transparent IGZO-TFTs Uses IGZO Source and Drain Electrodes with a Composite Insulation Layer Structure

Amorphous indium–gallium–zinc–oxide thin-film transistors using organic–inorganic hybrid films deposited by low-temperature plasma-enhanced chemical vapor deposition for all dielectric layers

Amorphous InGaZnO Thin Film Transistors with Sputtered Silver Source/drain and Gate Electrodes

Influence of Source and Drain Contacts on the Properties of Indium-Gallium Zinc-Oxide Thin-Film Transistors Based on Amorphous Carbon Nanofilm As Barrier Layer