Abstract:Cu3SbSe4, featuring its earth-abundant, cheap, nontoxic and environmentally friendly constituent elements, can be considered as a promising intermediate temperature thermoelectric (TE) material. Herein, a series of p-type Bi-doped Cu3Sb1−xBixSe4 (x = 0–0.04) samples were fabricated through melting and hot pressing process, and the effects of isovalent Bi-doping on their TE properties were comparatively investigated by experimental and computational methods. TEM analysis indicates that Bi-doped samples consist of Cu3SbSe4 and Cu2−xSe impurity phases, which is in good agreement with the results of XRD, SEM and XPS. For Bi-doped samples, the reduced electrical resistivity (ρ) caused by the optimized carrier concentrations and enhanced Seebeck coefficient derived from the densities of states near the Fermi level give rise to a high power factor of ~ 1000 µWm−1 K−2 at 673 K for the Cu3Sb0.985Bi0.015Se4 sample. Additionally, the multiscale defects of Cu3SbSe4-based materials involving point defects, nanoprecipitates, amorphous phases and grain boundaries can strongly scatter phonons to depress lattice thermal conductivity (κlat), resulting in a low κlat of ~ 0.53 Wm−1 K−1 and thermal conductivity (κtot) of ~ 0.62 Wm−1 K−1 at 673 K for the Cu3Sb0.98Bi0.02Se4 sample. As a consequence, a maximum ZT value ~ 0.95 at 673 K is obtained for the Cu3Sb0.985Bi0.015Se4 sample, which is ~ 1.9 times higher than that of pristine Cu3SbSe4. This work shows that isovalent heavy element doping is an effective strategy to optimize thermoelectric properties of copper-based chalcogenides.

Effect of Pb Doping on the Thermoelectric Performance of Eco-Friendly Cu 3 SbS 4

Enhancement of low-temperature thermoelectric performance via Pb doping in Cu3SbSe4

Preparation and Enhanced Thermoelectric Performance of Pb-doped Tetrahedrite Cu12-xPbxSb4S13

Band Engineering Through Pb‐Doping of Nanocrystal Building Blocks to Enhance Thermoelectric Performance in Cu3SbSe4

Effects of bismuth doping on the thermoelectric properties of Cu 3SbSe4 at moderate temperatures

Doping-mediated stabilization of copper vacancies to promote thermoelectric properties of Cu2−xS

Enhanced Thermoelectric Properties of Cu3SbSe4 Compounds by Isovalent Bismuth Doping

Bi and Sn Co-Doping Enhanced Thermoelectric Properties of Cu3SbS4 Materials with Excellent Thermal Stability.

Thermoelectric Properties of BiCuSO Doped with Pb

High Performance Thermoelectrics from Earth-Abundant Materials: Enhanced Figure of Merit in PbS by Second Phase Nanostructures.

Unlocking the Potential of Cu3SbSe3: Ultralow Thermal Conductivity and Enhanced Thermoelectric Performance

Enhanced thermoelectric performance of Cu12Sb4S13___etrahedrite via nickel doping

Enhanced thermoelectric performance of BiCuSO by Pb doping and Se alloying

Enhanced Thermoelectric Performance of PbSe Co-Doped with Ag and Sb

Enhancement of thermoelectric performance of Cu 1.98 Se by Pb doping

PbS–Pb–Cu x S Composites for Thermoelectric Application

Enhanced thermoelectric performance of Cu12Sb4S13-delta tetrahedrite via nickel doping

Effects of Sb Deviation from Its Stoichiometric Ratio on the Micro- and Electronic Structures and Thermoelectric Properties of Cu12Sb4S13.

High Thermoelectric Performance in Earth‐Abundant Cu3SbS4 by Promoting Doping Efficiency Via Rational Vacancy Design

Enhanced thermoelectric properties of Pb1-xBixS prepared with hydrothermal synthesis and microwave sintering

Structural features and thermoelectric performance of Sb- and Bi-doped Cu2SnSe3 compounds