Abstract:This article presents an 18 similar to 30 GHz vector-sum phase shifter for wireless application in the millimeter-wave regime. It is composed of an I/Q signal generator, two variable-gain amplifiers (VGA), and a digital-to-analog converter with a quadrant selector. To attain wideband quadrature signal, a two-stage hybrid based on transformers is proposed to realize the I/Q signal generator. The first- and second-stage hybrids are designed with different resonating frequencies. As a result, the amplitude and phase errors of the I/Q signal generator are significantly decreased in a wide frequency band. In addition, theoretical analysis based on a simplified equivalent-circuit model is performed to guide the circuit implementation, and its correctness is demonstrated by electromagnetic simulation. To mitigate the impact of the VGAs' parasitics on the phase performance, a capacitive-neutralization technique is applied to cancel parasitics of transistors in the VGAs. A prototype circuit is designed using a 130-nm SiGe BiCMOS process. The measured results show that the circuit achieves a root-mean-square (RMS) amplitude error of less than 1.4 dB and an RMS phase error of 1.4 degrees similar to 3.4 degrees across 18 similar to 32 GHz. The tested peak gains of all the phase states are -1 similar to 4.5 dB with an input balun (approximate to 1.9 dB loss) and an output balun (approximate to 2 dB loss) at 22 GHz. Also, the input 1-dB compression point and noise figure are tested, which are >=-1 dBm and <= 15.5 dB in the targeting frequency band.

An Area-Saving Balun for Multiband IoT Transmitter

Compact CMOS Baluns for the 4–10 GHz Band Applications

Three-solenoid Windings Transformer Baluns on CMOS-grade Silicon Substrate

Design of Millimeter-Wave Transformer Balun with Isolation Circuit in Silicon Based Technology

An 18 similar to 30 GHz Vector-Sum Phase Shifter With Two-Stage Transformer-Based Hybrid in 130-nm SiGe BiCMOS

20 . 6 A 0 . 6 V 32 . 5 mW Highly Integrated Receiver for 2 . 4 GHz ISM-Band Applications

A Power Mixer Based Dual-Band Transmitter for NB-IoT Applications

800Mhz~2.5ghz Miniaturized Multi-layer Symmetrical Stacked Baluns for Silicon Based RF ICs

1.34-To-16.37 GHz On-Chip Balun Based on Asymmetric Stacked Spiral Transformers

A Single Chain 800m/1.8g/2.4ghz Multistandard Transceiver with Multibranch Transformer for Low-Cost IoT Applications.

Design Analysis of Integrated Passive Device-Based Balun Devices with High Selectivity for Mobile Application

A Transmitter with Improved Power Efficiency Realized by Integrated Transformer Balun in 130nm Si Technology

A Compact 1.08–5.94 GHz Balun with 1○/0.07 Db Phase-/Amplitude-Imbalances Using Reverse Series Paths

A high-gain wideband balun-LNA with multiple noise-optimized technique

Compact Ultra-Wideband Stacked-Spiral-Coupled Balun Using Center-Tapped Float-Shield and Port-Coupled Compensation Line

Three Compact Active Baluns with High Phase/Amplitude Balance and Low Power in 65-nm CMOS for Transceiver Applications

Compact 6.5-28.5 GHz On-Chip Balun with Enhanced Inband Balance Responses

Compact broadband Marchand balun with excellent imbalance performance for Si-based millimeter wave IC applications

Research on miniaturized balun in RF front end

A 0.13-μm CMOS 0.8–10.6GHz low noise amplifier with active balun for multi-standard applications

A Broadband Monolithic Balun Based on 0.13μ CMOS m Process Using Planar-Spiral Transformers