Abstract:This article presents an 18 similar to 30 GHz vector-sum phase shifter for wireless application in the millimeter-wave regime. It is composed of an I/Q signal generator, two variable-gain amplifiers (VGA), and a digital-to-analog converter with a quadrant selector. To attain wideband quadrature signal, a two-stage hybrid based on transformers is proposed to realize the I/Q signal generator. The first- and second-stage hybrids are designed with different resonating frequencies. As a result, the amplitude and phase errors of the I/Q signal generator are significantly decreased in a wide frequency band. In addition, theoretical analysis based on a simplified equivalent-circuit model is performed to guide the circuit implementation, and its correctness is demonstrated by electromagnetic simulation. To mitigate the impact of the VGAs' parasitics on the phase performance, a capacitive-neutralization technique is applied to cancel parasitics of transistors in the VGAs. A prototype circuit is designed using a 130-nm SiGe BiCMOS process. The measured results show that the circuit achieves a root-mean-square (RMS) amplitude error of less than 1.4 dB and an RMS phase error of 1.4 degrees similar to 3.4 degrees across 18 similar to 32 GHz. The tested peak gains of all the phase states are -1 similar to 4.5 dB with an input balun (approximate to 1.9 dB loss) and an output balun (approximate to 2 dB loss) at 22 GHz. Also, the input 1-dB compression point and noise figure are tested, which are >=-1 dBm and <= 15.5 dB in the targeting frequency band.

800Mhz~2.5ghz Miniaturized Multi-layer Symmetrical Stacked Baluns for Silicon Based RF ICs

Compact CMOS Baluns for the 4–10 GHz Band Applications

Three-solenoid Windings Transformer Baluns on CMOS-grade Silicon Substrate

Design of Millimeter-Wave Transformer Balun with Isolation Circuit in Silicon Based Technology

Compact dual-mode dual-band balun filter using double-sided parallel-strip line

An 18 similar to 30 GHz Vector-Sum Phase Shifter With Two-Stage Transformer-Based Hybrid in 130-nm SiGe BiCMOS

A Compact 2-18Ghz Ultra-Wideband Frequency-conversion T/R Module Based on a 3D Heterogeneous Integrated Process

An 18~30 GHz Vector-Sum Phase Shifter with Two-Stage Transformer-Based Hybrid in 130-Nm SiGe BiCMOS

An Area-Saving Balun for Multiband IoT Transmitter

Planar Compact Dual-Band Balun with Flexible Frequency Ratios

Low-loss Balun Design and Compact Modeling for RF/millimeter-wave Circuit Application

A Broadband Monolithic Balun Based on 0.13μ CMOS m Process Using Planar-Spiral Transformers

Analysis and Design of Broadband Balance-Compensated Transformer Baluns for Silicon-Based Millimeter-Wave Circuits

A MINIATURIZED PRINTED DIPOLE ANTENNA WITH V-SHAPED GROUND FOR 2.45 GHZ RFID READERS

A Broadband Monolithic Balun Based on 0.13/spl mu/m CMOS Process Using Planar-Spiral Transformers

A 0.13-μm CMOS 0.8–10.6GHz low noise amplifier with active balun for multi-standard applications

An Advanced Broadband Absorptive Balun for Modern Communication Systems

Transformer-Based Low Voltage Design of 17 GHz Mixers with On-chip Balun Using 0.13-¿M Standard CMOS Process

A 5.1 Dbm 127–162 GHz Frequency Sextupler with Broadband Compensated Transformer-Based Baluns in 22nm FD-SOI CMOS

A 0.13-Mu M Cmos 0.1-12 Ghz Active Balun-Lna For Multi-Standard Applications

The Design of a New Spiral Inductor Balun Used in RF/MW Based on 0.13&#x03bc;m CMOS Process