Abstract:It is extremely difficult to obtain high output power with silicon based processes, which presents one of the greatest challenges for realizing fully integrated transceivers, especially at millimeter-wave frequencies. For this reason, various power combining methods have been proposed to achieve higher power levels.In this paper, a novel power combining method suitable for millimeter-wave applications is presented. The power combining network is synthesized in package utilizing wafer level packaging technology, with an array of power sources of moderate output power capability assumed to be distributed on chip, which means applying further combining in addition to existing on-chip power combining scheme for potentially even higher output power is possible.The power combining network is composed of more basic power combining units, each consisting of one substrate integrated waveguide (SIW) resonator coupling four lambda/4 standing-wave resonators, which can be synthesized using two quarter-wavelength vertical vias with one end open and the other end shorted. For power combining purpose, the open end of each lambda/4 resonator is connected to the differential output of one on-chip power source, while the shorted end is realized using one of the two metal plates of the SIW resonator. The coupling between the SIW resonator and lambda/4 resonators is through slotting on the metal plate to allow magnetic leakage so that oscillation in lambda/4 resonators will excite the SIW resonator to oscillate. As the quality factor of the SIW resonator is much larger than those of lambda/4 resonators, energy is mainly confined in the cavity of the SIW resonator so that power combing is achieved.Example design for 60 GHz application is detailed in the paper with simulation results using commercial CST software showing the effectiveness of the power combining method.

Design of Millimeter-Wave Transformer Balun with Isolation Circuit in Silicon Based Technology

Three-solenoid Windings Transformer Baluns on CMOS-grade Silicon Substrate

Compact CMOS Baluns for the 4–10 GHz Band Applications

A Novel Compact Dual-Band Antenna Array With High Isolations Realized Using the Neutralization Technique

Novel Millimeter-Wave Power Combining Utilizing Wafer Level Packaging Technology

Experimental Characterization of Hybrid Temperature and Frequency Effects on the Performance of Transformers on Silicon Substrate

A Broadband Monolithic Balun Based on 0.13μ CMOS m Process Using Planar-Spiral Transformers

A Broadband Monolithic Balun Based on 0.13/spl mu/m CMOS Process Using Planar-Spiral Transformers

Analysis and Design of Broadband Balance-Compensated Transformer Baluns for Silicon-Based Millimeter-Wave Circuits

Modified Broadband Ruthroff-Type Transmission Line Transformer Balun for Isolation-Enhanced Passive Mixer Design

An 18~30 GHz Vector-Sum Phase Shifter with Two-Stage Transformer-Based Hybrid in 130-Nm SiGe BiCMOS

An 18 similar to 30 GHz Vector-Sum Phase Shifter With Two-Stage Transformer-Based Hybrid in 130-nm SiGe BiCMOS

A Fully Integrated, Low-Cost, High Channel Utilization Digital Isolator in Standard CMOS with 50mbps and 100kv/μs CMTI

Design of Monolithic Broadband Balun Based on Planar-Spiral Inductors

Ultracompact isolated multilayer broadside-coupled balun with arbitrary isolation bandwidth

Transformer-Based Low Voltage Design of 17 GHz Mixers with On-chip Balun Using 0.13-¿M Standard CMOS Process

Modeling and Design of a Medium Frequency Transformer with High Isolation and High Power-Density

Low-loss Balun Design and Compact Modeling for RF/millimeter-wave Circuit Application

A Unified-Mode Analysis Method for Symmetric Networks and Its Application to Balun Design

The Design of a New Spiral Inductor Balun Used in RF/MW Based on 0.13&#x03bc;m CMOS Process

800Mhz~2.5ghz Miniaturized Multi-layer Symmetrical Stacked Baluns for Silicon Based RF ICs