Abstract:The problem of ammonium bisulfate (ABS) deposition blocking and corroding air preheaters and economizers in boilers became severe, as the selective catalyst reduction (SCR) system was widely used in the coal-fired boilers to meet the stringent nitrogen oxide (NOx) discharge standard. In this study, an online digital image technique was applied to investigate the growth of the deposition of fly ash and ABS blend in a drop tube furnace (DTF). The deposition was measured on a temperature controlled deposition probe. The results of the image technique showed that the surface temperature of the deposition probe had a negative effect on stable thicknesses of the blend depositions and the stable thicknesses for cases 1 (553 K), 2 (513 K), and 3 (473 K) are 4.78, 5.26, and 7.64 mm, respectively. Meanwhile, the relative variation of the heat flux Q(R) for Cases 1, 2, and 3 are 17.8%, 33.8%, and 40.2%. The deposition in the lower deposition surface temperature has a greater effect on the heat transfer efficiency. In order to understand the deposition formation of fly ash and ABS blend, the X-ray diffraction (XRD), X-ray fluorescence (XRF), and the scanning electron microscopy (SEM) analysis were undertaken of the blend deposition. The results indicated that the content of ABS in the bottom part deposition increased as the probe surface temperature decreases, and this would result in more agglomerates in the deposition according to the observations of the SEM and the growth behavior of the deposition was influenced. Meanwhile, the results show that the deposition characteristics of ABS and fly ash blend is strongly influenced by the distribution and the condensation behavior of ABS. This work makes a contribution to a deeper understanding of deposition characteristics of ammonium bisulfate and fly ash blend, which is important for boilers to control the blend deposition in air preheaters and economizers.

ICOPE-15-C103 Mechanism Analysis of Surface Deposition Layer on the Flue Gas Cooler Caused by Ammonia Escape

Analysis of Formation and Growth Process of Ash Deposition on the Convective Heating Surface of a 400t/d MSW Incinerator Based on Different Operating Days

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

Streamer Plasma Induced Ammonia Flue Gas Desulfurization

Investigation on ash fouling formation of induced fan blade and heat exchanger surface in a 1000MW coal-fired power plant

Study on the effects of the surface temperature on the formation of ammonium chloride and fly ash deposits

Effect of Fouling Layer (Acid–Ash Reaction) on Low-Temperature Corrosion Covering Heating Surface in Coal-Fired Flue Gas

Analysis of Scaling on Absorber Wall of CFB-FGD System and Its Mechanism

Analysis of ammonium bisulfate/sulfate generation and deposition characteristics as the by-product of SCR in coal-fired flue gas

Investigation of the Deposition Characteristics of Ammonium Bisulfate and Fly Ash Blend Using an On-Line Digital Image Technique: Effect of Deposition Surface Temperature

Investigation on the influence of sulfur and chlorine on the initial deposition/fouling characteristics of a high-alkali coal

Analysis of Scaling on Gas-Gas Heater Surfaces of Wet Flue Gas Desulfurization Systems

Study on the phase transformation mechanism and influencing factors of inorganic condensable particulate matter from coal-fired power plants

Fouling Characteristics of Coal Biomass Co-Combustion and the Influence of the Deposition Surface

Study on reduction characteristics of Fe species in coal ash under SNCR condition

In-situ sampling investigation of deposition and corrosion of convective heating surfaces in a grate type municipal solid waste incineration plant: a case study

Experimental Research Of Co2 Removal By Ammonia Solutions From Flue Gas Of Coal-Fired Power Plant

Absorber Corrosion Performance for CO_2 Capture Using an Amine Absorbant in a Coal-Fired Power Plant

Migration and Emission Characteristics of Ammonia/Ammonium through Flue Gas Cleaning Devices in Coal-Fired Power Plants of China

The Mineralogy Analysis Of Ash Deposition In Refractory Zones In A W-Flame Boiler

Experimental study on co-firing characteristics of ammonia with pulverized coal in a staged combustion drop tube furnace