Abstract:Tungsten carbide (WC), celebrated for its exceptional strength, hardness, and chemical inertness, serves as an exemplary reinforcement for copper (Cu) matrix composite (CMC) coatings, significantly enhancing their wear and corrosion resistance. However, the inherent poor wettability and interfacial bonding between WC and Cu during the cold spray additive manufacturing process pose challenges to further performance improvement of these coatings. This study investigates cold-sprayed CMC coatings reinforced with WC particles, both with and without an electroless plated cobalt (Co) shell (Co@WC; at 10 wt.% and 20 wt.%), focusing on their microstructure, mechanical properties, tribological behavior, and electrochemical corrosion resistance. The findings indicate a reduction in CMC coatings` porosity and mean free path (MFP) of reinforcement particles with increasing reinforcement content. Despite slight Co shell damage during deposition, ceramic retention is notably enhanced, reaching up to 149.3%. The microhardness and wear resistance of CMC coating are improved with decreased MFP and increased ceramic content. Compared to the Cu coating, the microhardness of CMC coatings escalates by up to 32.9% (151.8HV0.1), and the specific wear rate is dramatically reduced by up to 84.2%. The Co shell effectively prevents the detachment of Co@WC particles, thereby enhancing the bending and wear resistance. Electrochemical corrosion tests, encompassing open circuit potential (EOCP), polarization curve, and electrochemical impedance spectroscopy (EIS), indicate that lower porosity, high ceramic content and the Co shell substantially boost the corrosion resistance of the CMC coating. Specifically, the coating with 20 wt.% Co@WC (Cu20(Co@WC)) demonstrates superior corrosion resistance compared to the Cu coating, hinting at the potential for further enhancement with increased ceramic content.

Copper-based Tungsten Coating by CVD: Microstructure, Thermal Shock Resistance and Interfacial Bond Force

Thermal Shock Performance of CVD Tungsten Coating at Elevated Temperatures

Influence of Surface Morphology and Microstructure on Performance of CVD Tungsten Coating under Fusion Transient Thermal Loads

Effect of High Temperature Annealing on the Microstructure and Thermal Shock Resistance of Tungsten Coatings Grown by Chemical Vapor Deposition

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

Thermal Performance and Microstructure of Vacuum Plasma Sprayed Tungsten Coatings under Cyclic Heat Load

Study of Thick Tungsten Coatings Deposited on Various Molybdenum and Copper Substrates

Cold-sprayed Cu Matrix Composite Coatings with Core-Shell Structured Co@WC Reinforcements on Q235 Steel

Characterization of Thick Tungsten Coating on Cu Alloy Substrate Prepared by Electrodeposition

Effect of Copper on Microstructure and Performance of WC/NiAl/TiC Composite Coatings by Laser Cladding

Surface morphology and crystal orientation of electrodeposited tungsten coatings with different pulse parameters

Factors affecting explosive compaction–sintering of tungsten–copper coating on a copper surface

Effect of heat treatment on microstructure and properties of WC reinforced co-based composite coating on copper

Microstructure of Chemical Vapor Transport Deposition Single Crystal Tungsten Coating Working at 1600°C

Explosive compact-coating of tungsten–copper alloy to a copper surface

Thermal shock behaviors of W/Cu joints with different structures

Oxidative Ablation Behavior of W‐Coated C/C Composites Prepared by Chemical Vapor Deposition with Heat Treatment

Preparation and thermal conductivity of tungsten coated diamond/copper composites

Oxidative ablation behavior of W‐coated C/C composites prepared by CVD with heat‐treatment

Microstructure and wear resistance of in-situ TiC reinforced Stellite 6 coating using PTA cladding

Comparative study on the properties and microscopic mechanism of Ti coating and W coating diamond-copper composites