Abstract:Most countries begin to replace the conventional halogen headlamps with the small-wattage Xe metal halide lamp as the source of the automotive headlamp.However,the design of its electronic ballast is quite complex and the price is very high.As a result,it is only applied to the headlamp of the advance cars.This paper presentes the electronic ballast for automotive lamp using simulation control,and mainly discusses the basal principle and designing way including the basal structure of the ballast circuits and the selection of the topology of the main circuit.The transient process of the Xe lamp during the start-up phase is extremely complex.Therefore,how to complete the control of the start-up process is the difficulty.This paper also presentes the way of the constant power control and igniting.Based on the experimental data from the laboratory prototype,the circuits can complete all the control tasks from the phase of start-up to steady,including the switch of the constant power control,the high voltage of igniting.

Electronic Ballast For High Pressure Sodium Lamp Based On Charge Pump Power Factor Correction Technique

A Digital Controlled Ballast for Metal Halide Lamp

Analysis of Electronic Ballast for HID Lamps with Auxiliary Resonant Loop Protection

Electronic Ballast for MHL Based on ARM Microcontroller

Electronic Ballast for Automotive Mercury Free HID Lamps Based on DSP

Investigation on Start-Up Characteristics of Automotive HID Lamps with Electronic Ballast

The Comparison and the Developing Expectation of the Two-Stage Low-Frequency Square-Wave HID Electronic Ballasts

New Control Strategy for a Two-Stage Low-Frequency Square-Wave Electronic Ballast for MHD Lamp

Power Control Strategy of Electronic Ballast for HID Lamps

Design of 400V/600W HPS Electric Ballast

Investigation On The Start-Up Of Low Wattage Metal Halide Lamp Controlled By Low-Frequency Square-Wave Ballast

Analysis and Design of Current Auxiliary Circuit for Automotive HID Lamp Ballast

Simulation on Electronic Ballast for High Pressure Sodium Lamps by PSIM

Flexible-controlled high power-density automotive HID electronic ballast using full-digital control mode

Electronic Ballast for Automotive Lamp Using Simulation Control

Novel single stage single switch PFC converter with constant power control for ballast for medium HID lamps

A Two-Stage Low-Frequency Square-Wave Electronic Ballast for Metal Halide Lamps Using Peak-Current Control Mode

LCLC resonant converter for multiple lamp operation ballast

New electronic ballast circuits for high intensity discharge lamps

A novel dimmable electronic ballast for HID lamps

Digital Eectronic Ballast for High Intensity Discharge Lamps