Abstract:Micro-electro-mechanic-system (MEMS) devices on flexible substrate are important for non-planar and non-rigid surface applications. In this paper, a novel and cost-effective fabrication process for an 8×8 MEMS temperature sensor array with a lateral dimension of 2.5mm×5.5mm on a polyimide flexible substrate is developed. A 40μm thick polyimide substrate is formed on a rigid silicon wafer using as a mechanical carrier throughout the fabrication by four successive spin coating liquid polyimide. The arrayed temperature sensing elements made of 1200Å sputtered platinum thin film on polyimide substrate show excellent linearity with a temperature coefficient of resistance of 0.0028/°C. The purposed sensor obtains a high sensitivity of 0.781Ω/°C at 8mA at constant drive current. Because of the low heat capacity and excellent thermal isolation, the temperature sensing element shows excellent high sensitivity and a fast thermal response. The finished devices are flexible enough to be folded and twisted achieving any desired shape and form. Employing spin-coated liquid polyimide substrate instead of solid polyimide sheet minimizes the thermal cycling as well as improves the production yield. This fabrication technique first introduces the spin-coated PDMS (Polydimethylsiloxane) interlayer between the silicon carrier and the polyimide substrate and makes the polyimide-based devices separate much easier and greatly simplifies the fabrication process with a high production yield. A non-successive two-stage cure procedure for the polyimide precursor is developed to meet low-temperature requirement of the PDMS interlayer. The fabrication procedure developed in this research is compatible with conventional MEMS technology through an optimized integration process. The novel flexible MEMS technology can benefit the development of other new flexible polyimide-based devices.

Process Development Of Negative Tone Dry Film Photoresist For Mems Applications

Design, Fabrication And Measurement Of Tan Thin Film Resistor Based On Mems Technology

Rapid Prototyping of Soft Lithography Masters for Microfluidic Devices Using Dry Film Photoresist in a Non-Cleanroom Setting

An Investigation On Neg Thick Film For Vacuum Packaging Of Mems

Fullerene Derivatives as Novel Resist Materials for Fabrication of MEMS Devices by Electron Beam Lithography

CO2‐Based Dual‐Tone Resists for Electron Beam Lithography

Fabricating Processes Of Free-Standing Silicon Nitride Thin Film For Mems Devices

Zr/V/Fe Thick Film for Vacuum Packaging of Mems

Development of polymer MEMS process technology as an approach to a sustainable production system

Processing Compatibility of ZnO Piezoelectric Film with MEMS Device

Fabrication of a high aspect ratio thick silicon wafer mold and electroplating using flipchip bonding for MEMS applications

Dry-Transferable Photoresist Enabled Reliable Conformal Patterning for Ultrathin Flexible Electronics

Towards Green 3D-Microfabrication of Bio-MEMS Devices Using ADEX Dry Film Photoresists

A single-mask dry-release process for fabrication of high aspect ratio SOI MEMS devices

Nanoscale Bilayer Mechanical Lithography Using Water as Developer

Angle Effect of Ultrasonic Agitation on the Development of Thick JSR THB-430N Negative UV Photoresist

Design and fabrication of MEMS devices using the integration of MUMPs, trench-refilled molding, DRIE and bulk silicon etching processes

Precise Patterning of Diamond Films for MEMS Application

A Novel Fabrication Process of MEMS Devices on Polyimide Flexible Substrates

A Single Mask Dry Releasing Process for Making High Aspect Ratio Soimemsdevices.