Abstract:This paper presents the numerical investigation for a shell-and-tube latent heat thermal energy storage system (LHTES) employing numerical modeling and simulation with the FLUENT software. The LHTES consist of coilers where the heat transfer fluid (HTF) flows and a cuboids shell filled with phase change material. The unsteady N-S equation and energy equation using enthalpy measurement to deal with the latent heat of melting/solidification are solved. The effect of the tube diameter on the heat charging performance is examined, and the result shows that the functional relationship between the diameter of the tube and phase-change-rate is not monotonic. The optimal diameter of the tube at 20mm is used in all the subsequent computations. The influence of natural convection on charging and discharging processes is analyzed with positive tube pitch, and the result shows that natural convection plays a crucial role in the charging process and significantly accelerates the melting process; thermal conduction is dominant in the discharging process during the phase change stage which makes the discharging process much slower than the charging. The effects of the initial inlet temperature and velocity of HTF on the charging and discharging processes are studied in the case while PCM has a specific initial temperature. The result indicates that the inlet HTF velocity does not show a significant effect on the charging and discharging processes; the inlet HTF temperature shows a substantial effect on both processes. The temperature changing processes with time at different locations are also analyzed to dig more profound characteristics of the phase change process.

Experimental Study Of Absorption Heat-Transformer With Vapor Absorption Inside Vertical Spiral Tube

Investigations on the Cycle Performance of a Diffusion Absorption Heat Transformer Using HCOOK As an Alternative to LiBr

Numerical Investigation of Heat Transfer Characteristics in a Shell- And-Tube Latent Heat Thermal Energy Storage System

Experimental Research on the Vapor Pressures of CaCl2–H2O and MgCl2–H2O As Working Fluids of Absorption Heat Transformers at High Temperature

Experimental Investigations on the Temperature Lift Performance of a Novel Diffusion Absorption Heat Transformer

Experimental study on three types of transcritical carbon dioxide heat pump water heater systems

Vapor−Liquid Equilibrium Study of an Absorption Heat Transformer Working Fluid of (HFC-32 + DMF)

Numerical and experimental investigation of the dynamic performance of absorption heat transformers under different solution conditions

Experimental Investigation on an Absorption Heat Transformer for Production of Hot Water or Steam Generation

Theoretical Investigations on the Cycle Performance of a Single-Pressure Diffusion Absorption Heat Transformer with LiBr–H2O-R134a-TEGDME

Performance Analysis of an Absorption Heat Transformer with Different Working Fluid Combinations

Design and Experimental Study of a Second Type Absorption Heat Exchanger

Vapor Pressure of Aqueous HCOOK Solution As Working Fluids of an Absorption Heat Transformer at High Temperature

Experimental assessment of a detachable plate falling film heat and mass exchanger couple using lithium bromide and water as working fluids

Study of the Natural Circulation Flow Boiling Heat Transfer Based On Partially Superhydrophilic Surface Modification

A mathematical model with experiments of single effect absorption heat pump using LiBr–H2O

Dynamic Modeling and Operation Characteristics Analysis of LiBr Absorption Heat Pump

Experimental Study on the Flash Evaporation Process of LiBrH2O Solution in an Absorption Heat Pump

The Influence of a Vertical Chevron Corrugated Plate on Wetting and Thermal Performance of a Detachable Plate-Type Falling Film Absorber

Performance Analysis on Compression-Assisted Absorption Heat Transformer: A New Low-Temperature Heating System with Higher Heating Capacity under Lower Ambient Temperature

Eexperimental Study On Flow Evaporation Heat Transfer Characteristics Inside Horizontal Three-Dimensional Enhanced Tubes