Abstract:A simulation model using the first thermodynamic law is first proposed to estimate the performance of diffusion absorption heat transformer, which could potentially improve energy utilization efficiency and reduce CO2 emission. Thermodynamic analyses are performed to investigate the cycle performance when H2O is employed as refrigerant, LiBr as absorbent for H2O, R134a as diffusion gas and TEGDME as absorbent for R134a. Analyses aim to optimize system COP under specified temperature of two generators, two absorbers, evaporator and condenser, and compare the influence of the six temperatures on COP. The results under design conditions show that larger generation efficiency of R134a and smaller mass fraction of LiBr in H2O–LiBr solution are beneficial to COP improvement, but they are limited by the operating conditions. There is an optimal ratio of H2O–LiBr solution mass flow rate to R134a mass flow rate for an optimal COP, and the optimal ratio decreases with the increase of LiBr mass fraction in H2O–LiBr solution. The highest COP of 0.1701 is reached with the optimal ratio of 1.743. In addition, under design-off conditions, the temperatures of refrigerant generator and evaporator have the greatest influence on COP while the temperature of diffusion gas generator has the least influence. The diffusion absorption heat transformer will provide a new way to lift temperature of low grade heat without electricity input which can further improve the energy utilization efficiency and reduce the CO2 emission.

Performance Analysis of an Absorption Heat Transformer with Different Working Fluid Combinations

Vapor−Liquid Equilibrium Study of an Absorption Heat Transformer Working Fluid of (HFC-32 + DMF)

A Hybrid Resorption-Compression Heat Transformer for Energy Storage and Upgrade with a Large Temperature Lift

Experimental Research on the Vapor Pressures of CaCl2–H2O and MgCl2–H2O As Working Fluids of Absorption Heat Transformers at High Temperature

Analysis of a Combined Trilateral Cycle - Organic Rankine Cycle (TLC-ORC) System for Waste Heat Recovery

Investigations on the Cycle Performance of a Diffusion Absorption Heat Transformer Using HCOOK As an Alternative to LiBr

Theoretical Investigations on the Cycle Performance of a Single-Pressure Diffusion Absorption Heat Transformer with LiBr–H2O-R134a-TEGDME

Performance Analysis of the Two Stage Heat Transformer

Thermodynamic Analysis of an Ammonia-Water Double Absorption-Resorption Heat Transformer System

Thermodynamic analysis for LiBr-H2O absorption heat transformer

Double-Lift Parallel Mode Absorption Heat Transformer With The Ternary Working Fluid Tfe-H2o-E181

EXPERIMENTAL STUDY ON THE ABSORPTION HEAT TRANSFORMER FOR RECOVERING THE LOW-TEMPERATURE WASTE HEAT

Thermodynamic Performance of a Double-Effect Absorption Heat-Transformer Using TFE/E181 As the Working Fluid

Experimental Investigation on an Absorption Heat Transformer for Production of Hot Water or Steam Generation

Heat transfer and thermodynamic performance of LiBr/H2O absorption heat transformer with vapor absorption inside vertical spiral tubes

Experimental Investigations on the Temperature Lift Performance of a Novel Diffusion Absorption Heat Transformer

THERMODYNAMIC ANALYSIS AND COMPARISON OF SINGLE EFFECT WATER-LITHIUM BROMIDE ABSORPTION HEAT TRANSFORMER UNDER THE HIGH- AND LOW-TEMPERATURE CONDITIONS

Application of Absorption Heat Transformer to Recover Waste Heat from a Synthetic Rubber Plant

Performance research of a solution cross-type absorption-resorption heat transformer using NH3/H2O work fluid

Vapor Pressure of Aqueous HCOOK Solution As Working Fluids of an Absorption Heat Transformer at High Temperature

Experimental Study of Thermodynamic Performance of High Temperature Absorption Heat Transformer