Abstract:A simulation model using the first thermodynamic law is first proposed to estimate the performance of diffusion absorption heat transformer, which could potentially improve energy utilization efficiency and reduce CO2 emission. Thermodynamic analyses are performed to investigate the cycle performance when H2O is employed as refrigerant, LiBr as absorbent for H2O, R134a as diffusion gas and TEGDME as absorbent for R134a. Analyses aim to optimize system COP under specified temperature of two generators, two absorbers, evaporator and condenser, and compare the influence of the six temperatures on COP. The results under design conditions show that larger generation efficiency of R134a and smaller mass fraction of LiBr in H2O–LiBr solution are beneficial to COP improvement, but they are limited by the operating conditions. There is an optimal ratio of H2O–LiBr solution mass flow rate to R134a mass flow rate for an optimal COP, and the optimal ratio decreases with the increase of LiBr mass fraction in H2O–LiBr solution. The highest COP of 0.1701 is reached with the optimal ratio of 1.743. In addition, under design-off conditions, the temperatures of refrigerant generator and evaporator have the greatest influence on COP while the temperature of diffusion gas generator has the least influence. The diffusion absorption heat transformer will provide a new way to lift temperature of low grade heat without electricity input which can further improve the energy utilization efficiency and reduce the CO2 emission.

Experimental Investigations on the Temperature Lift Performance of a Novel Diffusion Absorption Heat Transformer

Investigations on the Cycle Performance of a Diffusion Absorption Heat Transformer Using HCOOK As an Alternative to LiBr

A Hybrid Resorption-Compression Heat Transformer for Energy Storage and Upgrade with a Large Temperature Lift

Theoretical Investigations on the Cycle Performance of a Single-Pressure Diffusion Absorption Heat Transformer with LiBr–H2O-R134a-TEGDME

Experimental Research on the Performance of a Gas Lift Bubble Pump Based on a Diffusion Generation Process

Experimental Investigation on an Absorption Heat Transformer for Production of Hot Water or Steam Generation

Experimental Research on the Performance of a Refrigerant Generating Bubble Pump Based on a Diffusion Generation Process with H2O HCOOK-R134a

Study on the Performance of a Novel Waste Heat Recovery System at Low Temperatures

A Theoretical Study of an Innovative Ejector Enhanced Vapor Compression Heat Pump Cycle for Water Heating Application

EXPERIMENTAL STUDY ON TWO TYPES OF TRANSCRITICAL CO2 HEAT PUMP WATER HEATER SYSTEM

Vapor−Liquid Equilibrium Study of an Absorption Heat Transformer Working Fluid of (HFC-32 + DMF)

Improvement of Thermal Performance of Novel Heat Exchanger with Latent Heat Storage

Experimental Research on the Vapor Pressures of CaCl2–H2O and MgCl2–H2O As Working Fluids of Absorption Heat Transformers at High Temperature

Vapor Pressure of Aqueous HCOOK Solution As Working Fluids of an Absorption Heat Transformer at High Temperature

Optimization Design of the Large Temperature Lift/drop Multi-Stage Vertical Absorption Temperature Transformer Based on Entransy Dissipation Method

Experimental study on using 85 °C low-grade heat to generate <120 °C steam by a temperature-distributed absorption heat transformer

Experimental Study of a New Ejector-Absorption Refrigeration Cycle Driven by Multi-Heat Sources

Performance Analysis on the Large Temperature Lift/Drop Multi-stage Vertical Absorption Temperature Transformer

Performance Analysis of an Absorption Heat Transformer with Different Working Fluid Combinations

Numerical and experimental investigation of the dynamic performance of absorption heat transformers under different solution conditions

Study on A New Ejection-Absorption Heat Transformer