Abstract:This article presents a 915-MHz ultra-low-power (ULP) sub-sampling phase-tracking receiver (SSPT-RX). It is targeted for the power-constrained devices that need short range but medium high-speed data receiving, such as the multi-channel neural stimulator with arbitrary waveform generation. The zero-intermediate frequency (zero-IF) phase-tracking receiver (PT-RX) topology is adopted to simplify the sub-sampling RX architecture with direct demodulation of frequency-shift keying (FSK) signal while improving the image frequency issue. The frequency of local oscillator (LO) is reduced by ten times with the proposed architecture, which leads to greatly reduced power consumption. Fabricated in 65-nm CMOS process, the RX chip occupies an active area of 0.58 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> . The RX consumes one of the lowest power consumptions of 164 <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\mu \text{W}$ </tex-math></inline-formula> from 0.5-/1-V supplies. It achieves an energy efficiency of 32.8 pJ/bit at a data rate of 5 Mb/s, which is improved by <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\sim 5.6\times $ </tex-math></inline-formula> compared to the state-of-the-art RXs. The measured sensitivity of 915-MHz FSK signal receiving is −69.5 dBm with an LO frequency of 91.5 MHz, which is 1/10 of the carrier frequency. The achieved RX sensitivity figure-of-merit (FoM) is 174.3 dB.

A 110pj/bit Star- 16QAM 915mhz Band Ultra-Low Power Receiver Based on Polar Architecture

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A CMOS Low Power K-band FMCW Radar Transceiver Front-End for AIOT Application

Low power high data rate GHz range receiver in 40nm CMOS technology

A 0.6V 32.5mw Highly Integrated Receiver for 2.4ghz ISM-Band Applications

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

A 253- $\mu $ W 2.4-Ghz SAW-Less Mixer-First Uncertain-IF Receiver with Blocker Tolerant for Long-Distance Ultralow-Power IoT

A 2.4 GHz 2.9 Mw Zigbee RF Receiver with Current-Reusing and Function-Reused Mixing Techniques

A 400MHz/900MHz Dual-Band Ultra-Low-Power Digital Transmitter for Biomedical Applications

A 9.4 Pj/bit 432 MHz 16-QAM/MSK Transmitter Based on Edge-Combining Power Amplifier

10 Mbps 0.3 Nj/bit OQPSK Transceiver IC for 400–450 MHz Medical Telemetry

2.4-GHz 16-QAM Passive Backscatter Transmitter for Wireless Self-power Chips in IoT

An 89 Μw MICS/ISM Band Receiver for Ultra-Low-power Applications.

A 164-W 915-MHz Sub-Sampling Phase-Tracking Zero-IF Receiver With 5-Mb/s Data Rate for Short-Range Applications

An 8mw Ultra Low Power 60ghz Direct-Conversion Receiver with 55db Gain and 4.9db Noise Figure in 65nm CMOS

A 400mhz 3–10mbps Transceiver IC with ∼0.3 Nj/bit TX/RX Energy Efficiency for Body Area Applications

A Low Power Impedance Transparent Receiver with Linearity Enhancement Technique for IoT Applications.

Ultra-low power, high-data rate, fully on-chip radio frequency on-off keying receiver for internet-of-things applications

A 120 Pj/bit ΔΣ-Based 2.4-Ghz Transmitter Using FIR-Embedded Digital Power Amplifier.

A 164-$\mu$ W 915-MHz Sub-Sampling Phase-Tracking Zero-IF Receiver With 5-Mb/s Data Rate for Short-Range Applications