Abstract:A fully integrated energy-efficient 10-Gb/s millimeter-wave transceiver with direct-modulation digital transmitter (TX) and I/ Q phase-coupled frequency synthesizer in 65 nm CMOS is presented. The transceiver consists of a direct-conversion receiver (RX), a digital TX with on-chip QPSK modulation, and a quadrature local-oscillation (LO) generation network with a 20-GHz phase-locked loop (PLL) frequency synthesizer. A T/R switch is integrated to interface with an E-shaped patch antenna. The QPSK modulation is directly realized in the I/ Q digital power amplifier (DPA), which simplifies the TX complexity and reduces the power consumption. A 20-GHz sub-sampling PLL (SSPLL) and a quadrature phased-coupled injection-locked oscillator (QILO) are integrated on-chip to generate 60-GHz quadrature LO signals. The QILO utilizes in-phase coupling technique to improve the LO I/ Q matching and phase noise performance. The RX achieves 7.1-dB noise figure (NF) and 25- to 47-dB dynamic gain range. The LO phase noise measured at the TX output is -115.6 dBc/Hz at 10 MHz offset from 60 GHz carrier. The measured error vector magnitude (EVM) of the TX is -23.9 dB for 10-Gb/s QPSK signals at 7-dBm output power. The EVM of the over-the-air (OTA) modulation-demodulation system is -13.8 dB for 10-Gb/s QPSK signals. The transceiver achieves the 10-Gb/s data rate while consuming 340.4 mW. The energy efficiency is 34 pJ/bit. This work demonstrates the fully functional wireless link based on the proposed mm-wave transceiver, which highlights the possibility of energy-efficient solution for future high throughputs mm-wave wireless systems.

10 Mbps 0.3 Nj/bit OQPSK Transceiver IC for 400–450 MHz Medical Telemetry

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

Low power high data rate GHz range receiver in 40nm CMOS technology

An Ultra-Low Power 400mhz OOK Transceiver for Medical Implanted Applications.

A 400mhz 3–10mbps Transceiver IC with ∼0.3 Nj/bit TX/RX Energy Efficiency for Body Area Applications

A 400MHz/900MHz Dual-Band Ultra-Low-Power Digital Transmitter for Biomedical Applications

Low-power transceiver analog front-end circuits for bidirectional high data rate wireless telemetry in medical endoscopy applications

An Energy-Efficient 10-Gb/s CMOS Millimeter-Wave Transceiver with Direct-Modulation Digital Transmitter and I/Q Phase-Coupled Frequency Synthesizer

A 400mhz 3-10mbps Transceiver Ic With Similar To 0.3 Nj/Bit Tx/Rx Energy Efficiency For Body Area Applications

A 5.9mw 50mbps CMOS QPSK/O-QPSK Transmitter Employing Injection Locking for Direct Modulation

A 20Mbps 5.8mw QPSK transmitter based on injection locking and Class-E PA for wireless biomedical applications

A 2.4ghz Low Power Wireless Transceiver Analog Front-End for Endoscopy Capsule System

Low Power High Data Rate Wireless Endoscopy Transceiver.

A Sub-$100\ \mu\mathrm{w}$ RF Transmitter with 41% Global Efficiency Using Third-Harmonic Edge-Combining Technique and Class-E PA for Low-Power Biomedical Applications

A 13 pJ/bit 900 MHz QPSK/16-QAM Band Shaped Transmitter Based on Injection Locking and Digital PA for Biomedical Applications

A Sub-100 W RF Transmitter with 41% Global Efficiency Using Third-Harmonic Edge-Combining Technique and Class-E PA for Low-Power Biomedical Applications

An Energy Efficient Fully Integrated OOK Transceiver SoC for Wireless Body Area Networks

Energy Efficient Transmitters For High Data Rate Biomedical Applications

A 0.66mw 400 MHz/900 MHz Transmitter IC for In-Body Bio-Sensing Applications.

An 11.05 Mw/Gbps Quad-Channel 1.25-10.3125 Gbps Serial Transceiver With A 2-Tap Adaptive Dfe And A 3-Tap Transmit Ffe In 40 Nm Cmos