Abstract:This paper has explored an ultra-low-power design of two 60-GHz direct-conversion receivers in a 65-nm CMOS process for single-channel and multi-channel applications under the IEEE 802.15.3c standard, respectively. One subthreshold biasing 0.4-V transconductance mixer is designed with a compact quadrature hybrid coupler (160 μm × 210 μm with measured 3-dB intrinsic loss) in receivers to achieve low power (8 mW for single channel and 12.4 mW for multi-channel) and high gain (55 dB for single channel and 62-dB for multi-channel). One three-stage low-noise amplifier employs high- Q passive matchings. A double-layer-stacked inductor is utilized for matching in the single-channel receiver and a high-impedance transmission line is utilized for matching in the multi-channel receiver, respectively. In addition, one new modified Cherry-Hooper amplifier is applied for the variable-gain amplifier design to achieve high gain-bandwidth product and high power efficiency. The single-channel receiver is implemented with 0.34- mm2 chip area. It is measured with a power consumption of 8 mW, a minimum single-sideband noise figure (NF) of 4.9 dB, a 3-dB bandwidth of 3.5 GHz, and a maximum conversion gain of 55 dB. The multi-channel receiver is implemented with 0.56- mm2 chip area. It is measured with a power consumption of 12.4 mW, a 3-dB bandwidth of 8 GHz (59.5 ~ 67.5 GHz), and a maximum conversion gain of 62 dB. The measurement results show that the two demonstrated 60-GHz direct-conversion receivers can achieve high gain and low NF with ultra-low power in 65-nm CMOS.

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

Low power high data rate GHz range receiver in 40nm CMOS technology

A 60ghz BiCMOS Self-Demodulator with Injection Locked Oscillator

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

Self-demodulated receiver at MM-wave range using SiGe technology

Integrated D-Band Transmitter and Receiver for Wireless Data Communication in 65 Nm Cmos

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

A 12-Mw 40–60-Ghz 0.18- $\mu {\hbox {m}}$ BiCMOS Oscillator-Less Self-Demodulator for Short-Range Software-Defined Transceivers

D-band CMOS Transmitter and Receiver for Multi-Giga-bit/sec Wireless Data Link

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A 0.6V 32.5mw Highly Integrated Receiver for 2.4ghz ISM-Band Applications

Design of Ultra-Low-Power 60-Ghz Direct-Conversion Receivers in 65-Nm CMOS

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

An 8mw Ultra Low Power 60ghz Direct-Conversion Receiver with 55db Gain and 4.9db Noise Figure in 65nm CMOS

A 26-Gb/s 140-Ghz OOK CMOS Transmitter and Receiver Chipset for High-Speed Proximity Wireless Communication

A fully integrated 0.18 μm SiGe BiCMOS low power 60 GHz receiver & transmitter for high data rate wireless communications

A 26-Gb/s 140-Ghz OOK CMOS Transmitter and Receiver Chipset for High-Speed Wireless and Dielectric Waveguide Communication

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

A Fully Integrated 60ghz Four Channel CMOS Receiver with 7ghz Ultra-Wide Bandwidth for IEEE 802.11ad Standard

Performance evaluation and receiver front-end design for on-chip millimeter-wave wireless interconnect

A 60-Ghz 3.0-Gb/s Spectrum Efficient BPOOK Transceiver for Low-Power Short-Range Wireless in 65-Nm CMOS