Abstract:This paper presents the design and measurement of an IEEE 802.11ad standard compatible RF transceiver for 60 GHz wireless communication systems. In addition to the traditional half-duplex (HD) mode, this work supports full-duplex (FD) operations to deliver better channel utilization and faster response times for the system. The isolation between the transmitter and receiver from the architecture design to system integration for FD operations has been fully considered. A digital self-interference cancellation (DSIC) is implemented in MATLAB to verify the FD performance. The super-heterodyne architecture with an intermediate frequency (IF) of 12 GHz is designed to suppress the image frequencies without using extra filters. A flexible phase-locked loop (PLL) synthesizer provides a local oscillator (LO) frequency with a 2 kHz resolution. Other than the time division duplex (TDD) mode used in the conventional 60 GHz system, a wide-bandwidth baseband digital variable-gain amplifier (DVGA) with a 3 dB bandwidth of more than 4 GHz also supports frequency division duplex (FDD) operations. The transceiver chip is fabricated using the Tower Jazz 0.18 μm SiGe BiCMOS process. With an on-board antenna, the transceiver covers all four channels in the 802.11ad standard, with MCS-12 (7.04 Gbps under 1.76 GSym/s and 16-QAM) under 1.5 m. In the proposed system design, the RF frontend-based self-interference (SI) suppression from the local transmitter to receiver LNA is around 54 dB. To achieve a practical FD application, the SI is further suppressed with the help of a digital SI compensation. The measured power consumption for the transmitter and receiver configurations are 194 mW and 231 mW, respectively, in HD mode and 398 mW for the FDD or FD operation mode.

A Fully Integrated 60ghz Four Channel CMOS Receiver with 7ghz Ultra-Wide Bandwidth for IEEE 802.11ad Standard

A Fully Integrated CMOS 60-Ghz Transceiver for IEEE802.11ad Applications.

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A compact dual-band direct-conversion CMOS transceiver for 802.11a/b/g WLAN

A 64db Gain 60ghz Receiver with 7.1db Noise Figure for 802.11ad Applications in 90nm Cmos

D-band CMOS Transmitter and Receiver for Multi-Giga-bit/sec Wireless Data Link

A 56 – 65 GHz Highly-Integrated FMCW Radar Transceiver with 7.8 Db NF and 8 GHz Chirp-Bandwidth in 65-Nm CMOS

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A 90-98-ghz FMCW Radar Transceiver Supporting Broadband Modulation in 65nm CMOS

Integrated D-Band Transmitter and Receiver for Wireless Data Communication in 65 Nm Cmos

A Low Noise, High Linearity CMOS Receiver for 802. 11b WLAN Applications

A 60-Ghz Wireless Transceiver With Dual-Mode Power Amplifier For Ieee 802.11ad In 65nm Cmos

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

A Full-Duplex 60 GHz Transceiver with Digital Self-Interference Cancellation

A Fully Integrated Reconfigurable Low-Power Sub-GHz Transceiver for 802.11ah in 65nm CMOS

An 8mw Ultra Low Power 60ghz Direct-Conversion Receiver with 55db Gain and 4.9db Noise Figure in 65nm CMOS

System-Level Design Of 60ghz Front-End For Gbps High Speed Wireless Communication

13.6 A 42gb/s 60ghz CMOS Transceiver for IEEE 802.11Ay.