Abstract:This paper presents the design and measurement of an IEEE 802.11ad standard compatible RF transceiver for 60 GHz wireless communication systems. In addition to the traditional half-duplex (HD) mode, this work supports full-duplex (FD) operations to deliver better channel utilization and faster response times for the system. The isolation between the transmitter and receiver from the architecture design to system integration for FD operations has been fully considered. A digital self-interference cancellation (DSIC) is implemented in MATLAB to verify the FD performance. The super-heterodyne architecture with an intermediate frequency (IF) of 12 GHz is designed to suppress the image frequencies without using extra filters. A flexible phase-locked loop (PLL) synthesizer provides a local oscillator (LO) frequency with a 2 kHz resolution. Other than the time division duplex (TDD) mode used in the conventional 60 GHz system, a wide-bandwidth baseband digital variable-gain amplifier (DVGA) with a 3 dB bandwidth of more than 4 GHz also supports frequency division duplex (FDD) operations. The transceiver chip is fabricated using the Tower Jazz 0.18 μm SiGe BiCMOS process. With an on-board antenna, the transceiver covers all four channels in the 802.11ad standard, with MCS-12 (7.04 Gbps under 1.76 GSym/s and 16-QAM) under 1.5 m. In the proposed system design, the RF frontend-based self-interference (SI) suppression from the local transmitter to receiver LNA is around 54 dB. To achieve a practical FD application, the SI is further suppressed with the help of a digital SI compensation. The measured power consumption for the transmitter and receiver configurations are 194 mW and 231 mW, respectively, in HD mode and 398 mW for the FDD or FD operation mode.

System-Level Design Of 60ghz Front-End For Gbps High Speed Wireless Communication

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

D-band CMOS Transmitter and Receiver for Multi-Giga-bit/sec Wireless Data Link

26.8-M THz Wireless Transmission of Probabilistic Shaping 16-QAM-OFDM Signals

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

A High Performance 2-Ghz Direct-Conversion Front End with Single-Ended RF Input in 0.13 Um CMOS

A Fully Integrated 60ghz Four Channel CMOS Receiver with 7ghz Ultra-Wide Bandwidth for IEEE 802.11ad Standard

Design And Simulation Of Low Noise Amplifier For Radio Frequency Front End Of Wireless Communication

A Fully Integrated CMOS 60-Ghz Transceiver for IEEE802.11ad Applications.

A 64db Gain 60ghz Receiver with 7.1db Noise Figure for 802.11ad Applications in 90nm Cmos

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

CMOS Mm-Wave Transceivers for Gbps Wireless Communication

A New 24/36-Ghz Transceiver Architecture for 60-Ghz Applications

A Full-Duplex 60 GHz Transceiver with Digital Self-Interference Cancellation

13.6 A 42gb/s 60ghz CMOS Transceiver for IEEE 802.11Ay.

Ultra-high Capacity 60-Ghz Fiber-Wireless Systems

A Low Voltage CMOS RF Front-End for IEEE 802.11b WLAN Transceiver

Performance evaluation and receiver front-end design for on-chip millimeter-wave wireless interconnect

CMOS mm-wave transceivers for Gbps wireless communication*

Automatic design for analog/RF front-end system in 802.11ac receiver

6 Gbps 16QAM Fully Integrated Receiver Using Optimized Neutralization Technique LNA in 90 Nm CMOS.