Abstract:This paper presents the design and measurement of an IEEE 802.11ad standard compatible RF transceiver for 60 GHz wireless communication systems. In addition to the traditional half-duplex (HD) mode, this work supports full-duplex (FD) operations to deliver better channel utilization and faster response times for the system. The isolation between the transmitter and receiver from the architecture design to system integration for FD operations has been fully considered. A digital self-interference cancellation (DSIC) is implemented in MATLAB to verify the FD performance. The super-heterodyne architecture with an intermediate frequency (IF) of 12 GHz is designed to suppress the image frequencies without using extra filters. A flexible phase-locked loop (PLL) synthesizer provides a local oscillator (LO) frequency with a 2 kHz resolution. Other than the time division duplex (TDD) mode used in the conventional 60 GHz system, a wide-bandwidth baseband digital variable-gain amplifier (DVGA) with a 3 dB bandwidth of more than 4 GHz also supports frequency division duplex (FDD) operations. The transceiver chip is fabricated using the Tower Jazz 0.18 μm SiGe BiCMOS process. With an on-board antenna, the transceiver covers all four channels in the 802.11ad standard, with MCS-12 (7.04 Gbps under 1.76 GSym/s and 16-QAM) under 1.5 m. In the proposed system design, the RF frontend-based self-interference (SI) suppression from the local transmitter to receiver LNA is around 54 dB. To achieve a practical FD application, the SI is further suppressed with the help of a digital SI compensation. The measured power consumption for the transmitter and receiver configurations are 194 mW and 231 mW, respectively, in HD mode and 398 mW for the FDD or FD operation mode.

A New 24/36-Ghz Transceiver Architecture for 60-Ghz Applications

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

A 0.6V 32.5mw Highly Integrated Receiver for 2.4ghz ISM-Band Applications

A 39 GHz Dual-Channel Transceiver Chipset with an Advanced LTCC Package for 5G Multi-Beam MIMO Systems

A 12-Mw 40–60-Ghz 0.18- $\mu {\hbox {m}}$ BiCMOS Oscillator-Less Self-Demodulator for Short-Range Software-Defined Transceivers

A Compact 2-18Ghz Ultra-Wideband Frequency-conversion T/R Module Based on a 3D Heterogeneous Integrated Process

A 71-to-86ghz, 20.4dbm $\mathbf{p}_{\mathbf{out}}$, 6.0db NF Transceiver with Quadrature Direct-Modulated Transmitter and Reflection-Less Heterodyne Receiver in 40nm CMOS

Design of Ultra-Low-Power 60-Ghz Direct-Conversion Receivers in 65-Nm CMOS

Automatic Analog Beamforming Transceiver for 60 GHz Radios

A Fully Integrated CMOS 60-Ghz Transceiver for IEEE802.11ad Applications.

A 71-to-86GHz, 20.4dBm <tex>$\mathbf{P}_{\mathbf{out}}$</tex>, 6.0dB NF Transceiver with Quadrature Direct-Modulated Transmitter and Reflection-Less Heterodyne Receiver in 40nm CMOS

A Reconfigurable Sliding-IF Transceiver for 400 MHz/2.4 GHz IEEE 802.15.6/ZigBee WBAN Hubs With Only 21% Tuning Range VCO

A Full-Duplex 60 GHz Transceiver with Digital Self-Interference Cancellation

24.9 A 128-QAM 60ghz CMOS Transceiver for IEEE802.11ay with Calibration of LO Feedthrough and I/Q Imbalance.

A 60 GHz heterodyne quadrature transmitter with a new simplified architecture in 90nm CMOS

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

A Fully-Integrated Reconfigurable Dual-Band Transceiver for Short Range Wireless Communications in 180 Nm CMOS.

A 20–32-Ghz Quadrature Digital Transmitter Using Synthesized Impedance Variation Compensation

A Reusable Superheterodyne Dual-Band Down-Conversion Mixer With Hybrid Linearity-Enhanced Technique for 5G Non-Contiguous Multiband NR

13.6 A 42gb/s 60ghz CMOS Transceiver for IEEE 802.11Ay.

A Low-Power Reconfigurable Multi-Band Sliding-If Transceiver For Wban Hubs In 0.18 Mu M Cmos