Abstract:This paper presents a 10.56-GHz transceiver with ultracompact transformer-based transmit/receive (T/R) switching via matching network reuse. The reused transformer can operate as T/R switch and impedance matching networks for a power amplifier (PA) and a low-noise amplifier (LNA) simultaneously. The T/R switch, PA, and LNA are fully codesigned, and the interstage matching networks of the PA and LNA are comatched with the T/R switch to improve the performance of the front end (FE). A three-coil transformer is introduced in the PA to improve the linearity and bandwidth of the FE in the transmit (TX) mode. A mode selection unit (MSU) is also utilized in LNA to improve the TX/RX isolation and the linearity of the FE in the TX mode. Utilizing the fully codesign technique in the FE, the bandwidth of the FE is extended to over 4.2 GHz in both the TX and RX modes. A novel “gm-cell-based” broadband programmable gain amplifier (PGA) and a third-order transconductance-capacitor (gm-c) low-pass filter (LPF) are used in analog baseband to provide over 24-dB gain and 1.8-GHz bandwidth adjustment range with ultralow dc power consumption. To prove the concept, the new architecture is implemented in 28-nm CMOS technology. Measurement results prove that the insertion loss of the proposed T/R switch introduced in both the TX and RX modes is ~0.5 dB, and benefiting from this, the RX obtained a 4.2-dB noise figure, and TX obtained 9.9- and 14.1-dBm OP1dB and Psat. The measured single sideband bandwidth of the transceiver is wider than 2.1 GHz in both the TX and RX modes.

A Fully-Integrated Reconfigurable Dual-Band Transceiver for Short Range Wireless Communications in 180 Nm CMOS.

A fully-integrated reconfigurable dual-band transceiver for short range wireless communication in 180nm CMOS

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

A compact dual-band direct-conversion CMOS transceiver for 802.11a/b/g WLAN

Two 180nm CMOS Wireless Transceivers for IoT Applications

An RF/baseband FDMA-interconnect Transceiver for Reconfigurable Multiple Access Chip-to-chip Communication

A Lower Power Reconfigurable Multi-Band Transceiver for Short-Range Communication

A Reconfigurable Multi-Mode Multi-Band Transmitter with Integrated Frequency Synthesizer for Short-Range Wireless Communication

A Fully Integrated Reconfigurable Low-Power Sub-GHz Transceiver for 802.11ah in 65nm CMOS

A 0.1∼4GHz receiver and 0.1∼6GHz transmitter with reconfigurable 10∼100MHz signal bandwidth in 65nm CMOS

A Fully Integrated QPSK/16-QAM D-Band CMOS Transceiver With Mixed-Signal Baseband Circuitry Realizing Digital Interfaces

A 71-to-86ghz, 20.4dbm $\mathbf{p}_{\mathbf{out}}$, 6.0db NF Transceiver with Quadrature Direct-Modulated Transmitter and Reflection-Less Heterodyne Receiver in 40nm CMOS

A 180nm CMOS wireless transceiver by utilizing guard band for narrowband IoT applications

A Reconfigurable Sliding-IF Transceiver for 400 MHz/2.4 GHz IEEE 802.15.6/ZigBee WBAN Hubs With Only 21% Tuning Range VCO

A Low-Power Reconfigurable Multi-Band Sliding-If Transceiver For Wban Hubs In 0.18 Mu M Cmos

A 0.1 Similar To 4ghz Receiver And 0.1 Similar To 6ghz Transmitter With Reconfigurable 10 Similar To 100mhz Signal Bandwidth In 65nm Cmos

A 10.56-Ghz Broadband Transceiver with Integrated T/R Switching Via Matching Network Reuse and 0.3–2.1-Ghz Baseband in 28-Nm CMOS Technology

A 71-to-86GHz, 20.4dBm <tex>$\mathbf{P}_{\mathbf{out}}$</tex>, 6.0dB NF Transceiver with Quadrature Direct-Modulated Transmitter and Reflection-Less Heterodyne Receiver in 40nm CMOS

A Bidirectional 56-72 GHz to 10.56 GHz Tranceiver Front-End with Integrated T/R Switches in 28-nm CMOS Technology

A High-Linearity WCDMA/GSM Reconfigurable Transceiver in 0.13- CMOS