Abstract:This paper presents a 10.56-GHz transceiver with ultracompact transformer-based transmit/receive (T/R) switching via matching network reuse. The reused transformer can operate as T/R switch and impedance matching networks for a power amplifier (PA) and a low-noise amplifier (LNA) simultaneously. The T/R switch, PA, and LNA are fully codesigned, and the interstage matching networks of the PA and LNA are comatched with the T/R switch to improve the performance of the front end (FE). A three-coil transformer is introduced in the PA to improve the linearity and bandwidth of the FE in the transmit (TX) mode. A mode selection unit (MSU) is also utilized in LNA to improve the TX/RX isolation and the linearity of the FE in the TX mode. Utilizing the fully codesign technique in the FE, the bandwidth of the FE is extended to over 4.2 GHz in both the TX and RX modes. A novel “gm-cell-based” broadband programmable gain amplifier (PGA) and a third-order transconductance-capacitor (gm-c) low-pass filter (LPF) are used in analog baseband to provide over 24-dB gain and 1.8-GHz bandwidth adjustment range with ultralow dc power consumption. To prove the concept, the new architecture is implemented in 28-nm CMOS technology. Measurement results prove that the insertion loss of the proposed T/R switch introduced in both the TX and RX modes is ~0.5 dB, and benefiting from this, the RX obtained a 4.2-dB noise figure, and TX obtained 9.9- and 14.1-dBm OP1dB and Psat. The measured single sideband bandwidth of the transceiver is wider than 2.1 GHz in both the TX and RX modes.

A High-Linearity WCDMA/GSM Reconfigurable Transceiver in 0.13- CMOS

A compact dual-band direct-conversion CMOS transceiver for 802.11a/b/g WLAN

A 130nm CMOS direct conversion transmitter for WCDMA

A high-linearity receiver RF front-end with a high-performance 25%-duty-cycle LO generator for WCDMA/GSM applications

A Fully-Integrated Reconfigurable Dual-Band Transceiver for Short Range Wireless Communications in 180 Nm CMOS.

A 0.1∼4GHz receiver and 0.1∼6GHz transmitter with reconfigurable 10∼100MHz signal bandwidth in 65nm CMOS

Analysis and Design of a High-Linearity Receiver RF Front-End with an Improved 25%-Duty-cycle LO Generator for WCDMA/GSM Applications

A Low-Power Reconfigurable Multi-Band Sliding-If Transceiver For Wban Hubs In 0.18 Mu M Cmos

A 0.1 Similar To 4ghz Receiver And 0.1 Similar To 6ghz Transmitter With Reconfigurable 10 Similar To 100mhz Signal Bandwidth In 65nm Cmos

A fully-integrated reconfigurable dual-band transceiver for short range wireless communication in 180nm CMOS

CMOS Highly Linear Direct-Conversion Transmitter for WCDMA with Fine Gain Accuracy

Design of a High-Linearity RF Front-End with IP2 Calibration for SAW-less WCDMA Receivers.

A multi-mode 1-V DAC+filter in 65-nm CMOS for reconfigurable (GSM, TD-SCDMA and WCDMA) transmitters

A 10.56-Ghz Broadband Transceiver with Integrated T/R Switching Via Matching Network Reuse and 0.3–2.1-Ghz Baseband in 28-Nm CMOS Technology

A Reconfigurable 0.7–2.6ghz Wideband Mixer for Multi-Mode Multi-Standard Receivers in 0.18μm RF CMOS

The RF module design for W-CDMA/GSM dual band and dual mode handset

Linearization of Mixers Using a Reconfigurable Transistor Pair for W-CDMA Mobile Terminals

A Reconfigurable Low Power Filter in 65 nm CMOS for Multi-standard Transmitters

A 0.1–6.0-Ghz Dual-Path SDR Transmitter Supporting Intraband Carrier Aggregation in 65-Nm CMOS

A tri-band, 2-RX MIMO, 1-TX TD-LTE CMOS transceiver.

A Reconfigurable Baseband Circuit Applied for Wimax Low-If Receivers