Abstract:This paper presents a 0.2 similar to 3.8-GHz in-band (IB) full-duplex (FD) mixer-first receiver based on a vector self-interference (SI) canceller. To ensure the wideband orthogonality of the reconstructed SI signal while minimizing the noise figure (NF) degradation in FD mode, a low insertion loss two-stage polyphase filter (PPF) with a lacking resistance and capacitance (LRC) structure is used in the SI canceller. A 6-bits passive capacitor digital to analog converter (C-DAC) attenuator not only realizes the high-precision amplitude adjustment of the reconstructed SI signal but also avoids the linearity limitation of the back-end modules of the canceller and reduces the noise contribution of the front-end modules at the canceller output. A four-phase mixer-first receiver with enhanced out-of-band (OOB) interference suppression is designed to provide sufficient linearity to reduce the SI-induced nonlinear distortion. As a proof of concept, a prototype FD receiver is fabricated in CMOS 65 nm technology and measured in chip-on-board (COB) package. Measurement results show that it can operate in the frequency range of 0.2 similar to 3.8-GHz with more than 25 dB SIC amount for 10 MHz bandwidth (BW) 64-QAM modulated signals in fixed (30 dB) channel attenuation test setup. The receiver achieves OOB input-referred third-order intercept point (OOB-IIP3) of +24 dBm and OOB input-referred second-order intercept point (OOB-IIP2) of +82 dBm at 1-GHz local oscillator (LO) frequency. In FD mode, the NF degradation is <= 1.5 dB. The effective IB-IIP3 and effective IB-IIP2 are enhanced by 15 dB and 28 dB, respectively. The power consumption of entire FD receiver including the SI canceller is less than 44 mW. The active chip area is 0.55 mm(2).

A 60ghz BiCMOS Self-Demodulator with Injection Locked Oscillator

Self-demodulated receiver at MM-wave range using SiGe technology

A 12-Mw 40–60-Ghz 0.18- $\mu {\hbox {m}}$ BiCMOS Oscillator-Less Self-Demodulator for Short-Range Software-Defined Transceivers

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

Low power high data rate GHz range receiver in 40nm CMOS technology

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

The Investigation and Optimisation of Phase-Induced Amplitude Attenuation in the Injection-Locked Ring Oscillators-Based Receiver

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A power efficient 60 GHz 90nm CMOS OOK receiver with an on-chip antenna

A 60-Ghz OOK Receiver with an On-Chip Antenna in 90 Nm CMOS.

A low power 60GHz OOK transceiver system in 90nm CMOS with innovative on-chip AMC antenna

A Low-Power Low-Noise 600mhz CMOS IF Demodulator for Superheterodyne Receivers.

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

An 8mw Ultra Low Power 60ghz Direct-Conversion Receiver with 55db Gain and 4.9db Noise Figure in 65nm CMOS

A Fully Integrated 60ghz Four Channel CMOS Receiver with 7ghz Ultra-Wide Bandwidth for IEEE 802.11ad Standard

A fully integrated 0.18 μm SiGe BiCMOS low power 60 GHz receiver & transmitter for high data rate wireless communications

A 0.2~3.8-Ghz Full-Duplex Receiver with More Than 25 Db Self-Interference Cancellation Using a C-DAC-Based Vector Canceller.

A super-regenerative pulsed UWB receiver combined with injection-locking

A 0.2~3.8-GHz Full-Duplex Receiver With More Than 25 dB Self-Interference Cancellation Using a C-DAC-Based Vector Canceller

SiP-based 60ghz 4&#x00d7;4 Antenna Array with 90nm CMOS OOK Modulator in LTCC

A 90nm-CMOS, 500Mbps, fully-integrated IR-UWB transceiver using pulse injection-locking for receiver phase synchronization