Abstract:This paper describes a low power 2.4GHz receiver front end with wideband frequency shift keying (FSK) modulation and a two-point modulation fractional-N PLL in 65nm CMOS. The wideband FSK relaxes design requirements of building blocks in the receiver, thus enabling low power and low complex receiver performance. To avoid the image-rejection problem of the conventional heterodyne receiver as well as the DC offset and LO leakage problems of the direct conversion receiver, a sliding-IF architecture is chosen for simple hardware implementation. Besides, a low voltage fractional-N hybrid PLL based on two-point modulation is designed for the transmitter design. To overcome the DCO nonlinearity with the low supply voltage, a dedicated 1-bit high-pass modulation path is used for robust two-point modulation, dissipating only 1mW from a 0.7V supply. The PLL can also be reconfigurable for the LO generation in the receiver. The receiver front end circuits including the LO generation PLL consume 2.24mW with a maximum voltage conversation gain of 57dB in post simulation. An energy efficiency of 0.21nJ/bit and a sensitivity of -84dBm could be achieved based on the simulation results.

The Investigation and Optimisation of Phase-Induced Amplitude Attenuation in the Injection-Locked Ring Oscillators-Based Receiver

A K-Band Low-Power Phase Shifter Based on Injection Locked Oscillator in 0.13 Μm CMOS Technology

A 3 Mw 54 GHz 0.18 Μm BiCMOS Voltage Controlled Oscillator with Supply Injection Locking

Low power high data rate GHz range receiver in 40nm CMOS technology

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

V-Band Injection-Locked Oscillator with 9 Ghz Locking Range

A Low Power Sub-GHz PLL with Optimized LO Distribution Circuit

A 60ghz BiCMOS Self-Demodulator with Injection Locked Oscillator

A 0.6V 32.5mw Highly Integrated Receiver for 2.4ghz ISM-Band Applications

20 . 6 A 0 . 6 V 32 . 5 mW Highly Integrated Receiver for 2 . 4 GHz ISM-Band Applications

A Low Phase Noise V-Band 40 Nm Cmos Phase Locked Loop For Wireless Communication

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A 53.1-to-64.5 GHz In-Phase Coupled Quadrature Injection-Locked Oscillator with Transformer-Based I/Q-Phase Differential Injection Scheme

Photonic Radiofrequency Receiver Utilizing a Phase Modulator and a Tunable Single Sideband Optoelectronic Oscillator

Frequency Stability Optimization of an OEO Using Phase-Locked-loop and Self-Injection-locking

Finely Tunable Coupled Optoelectronic Oscillator Based on Injection Locking and Phase Locked Loop

2.4Ghz 20mb/s FSK Receiver Front-End and Transmitter Modulation PLL Design for Energy-Efficient Short-Range Communicaiton

An Injection Locked Oscillator for Direction Conversion BPSK Modulation Applications

Comparison and Optimization of Phase Locked Loop and Injection Locking Techniques for Optoelectronic Oscillators

A Highly Linearized Ka-band Heterodyne Receiver using a Folded Class-AB Inductive Peaking Mixer and Magnetic-Self-Cancellation-Transformer-Based IF Amplifiers

Improving the Performance of the Injection-Locked Optoelectronic Oscillator by Using an Extra Feedback Loop