Abstract:Direct conversion receiver (DCR) architecture is a promising candidate in the radio frequency (RF) front end because of its low power consumption, low cost and ease of integration. However, flicker noise and direct current (DC) offset are large issues. Owing to the local oscillator (LO) frequency, which is half of the RF frequency, and the absence of a DC bias current that introduces no flicker noise, the subharmonic passive mixer (SHPM) core topology front end overcomes the shortcoming effectively. When more and more receivers (RX) and transmitters (TX) are integrated into one chip, the linearity of the receiver front end becomes a very important performer that handles the TX and RX feedthrough. Another reason for the requirement of good linearity is the massive electromagnetic interference that exists in the atmosphere. This paper presents a linearity-improved RF front end with a feedforward body bias (FBB) subharmonic mixer core topology that satisfies modern RF front end demands. A novel complementary derivative superposition (DS) method is presented in low noise amplifier (LNA) design to cancel both the third- and second-order nonlinearities. To the best knowledge of the authors, this is the first time FBB technology is used in the SHPM core to improve linearity. A Volterra series is introduced to provide an analytical formula for the FBB of the SHPM core. The design was fabricated in a 0.13 μm complementary metal oxide semiconductor (CMOS) process with a chip area of 750 μm × 1270 μm. At a 2.4 GHz working frequency, the measurement result shows a conversion gain of 36 dB, double side band (DSB) noise figure (NF) of 6.8 dB, third-order intermodulation intercept point (IIP3) of 2 dBm, LO–RF isolation of 90 dB and 0.8 mW DC offset with 14.4 mW power consumption at 1.2 V supply voltage. These results exhibit better LO–RF feedthrough and DC offset, good gain and NF, moderate IIP3 and the highest figure of merit compared to the state-of-the-art publications.

A Highly Linearized Ka-band Heterodyne Receiver using a Folded Class-AB Inductive Peaking Mixer and Magnetic-Self-Cancellation-Transformer-Based IF Amplifiers

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A High-Linearity 7–9-Ghz Receiver Front End with Strength-Oriented Nonlinearity Cancellation

A 60–90 GHz Mixer-First Receiver with Adaptive Temperature-Compensation Technique

A 0.1-1.9Ghz 65nm CMOS Variable-Gain Mixer-First Receiver with DSA and Noise-Shaping TIA.

A High Linearity Class AB Power Amplifier for Sub-1 GHz Applications

A Compact Ka-Band Eight-Element Four-Beam Receiver for Low-Earth-Orbit Satellite Communications in 65-Nm CMOS

High-Linearity Direct Conversion Receiver with the Transconductance Equalization Technique and DCOC Method

A 0.12mm2 K/Ka Band RX Front-end in 40-Nm CMOS with Inductor-Less LO Generators

A Linearity Improvement Front End with Subharmonic Current Commutating Passive Mixer for 2.4 GHz Direct Conversion Receiver in 0.13 Μm CMOS Technology

A K/Ka/V Triband Single-Signal-Path Receiver With Variable-Gain Low-Noise Amplifier and Constant-Gain Phase Shifter in 28-nm CMOS

A Hybrid Coupler-First 5ghz Noise-Cancelling Dual-Mode Receiver with +10dbm In-Band IIP3 in Current-Mode and 1.7db NF in Voltage-Mode.

A Low Power Impedance Transparent Receiver with Linearity Enhancement Technique for IoT Applications.

Highly Linear W-Band Receiver Front-End Based on Higher-Order Optical Sideband Processing

A 5.6-Db Noise Figure, 63–86-Ghz Receiver Using a Wideband Noise-Cancelling Low Noise Amplifier with Phase and Amplitude Compensation

A CMOS MedRadio Receiver RF Front-End with a Complementary Current-Reuse LNA

A high-linearity receiver RF front-end with a high-performance 25%-duty-cycle LO generator for WCDMA/GSM applications

A Baseband-Noise-Cancelling Mixer-First CMOS Receiver Frontend Attaining 220 MHz IF Bandwidth With Positive-Capacitive-Feedback TIA

A Low-Power, Compact, 0.1–5.5-Ghz, 40-Dbm IB OIP3 LNTA-First Receiver for SDR

A 0.1∼4GHz receiver and 0.1∼6GHz transmitter with reconfigurable 10∼100MHz signal bandwidth in 65nm CMOS

An Interference-Robust Reconfigurable Receiver with Automatic Frequency-Calibrated LNA in 65-Nm CMOS