Abstract:This article presents a single-signal-path tri (K/Ka/V)-band receiver (RX) featuring area/cost-effective support for various millimeter-wave phased-array applications. A triple-coupling transformer (TCT) at the common-gate input stage of the RX low-noise amplifier (LNA) is proposed for triband impedance matching and $g_{m}$ -boosting. By augmenting each low-parasitic pMOS switched inductor load with a pMOS variable resistor in parallel, the variable-gain functionality is merged into this LNA to cover a wide input-signal range in a low-overhead manner. An active single-balanced mixer (SBM) for radio frequency (RF)-intermediate frequency (IF) downconversion is adopted to eliminate a wideband balun. Poor RF-IF and local-oscillator (LO)-IF isolations and low IIP<sub>2</sub> normally inherited in an SBM are avoided by setting the IF particularly. The wideband response of an on-chip LO buffer is realized through input resistor coupling and output inductor peaking. Furthermore, a constant-gain phase shifter (CGPS) at IF is proposed to benefit the orthogonal gain-and-phase control preferred by beam steering. This CGPS uses an amplitude-only feedback loop to retain the gain without baseband equalization. Fabricated in a 28-nm bulk CMOS technology, this RX exhibits variable power gains of 12.5–33.2 dB (at 24 GHz), 13.4–34.6 dB (at 33 GHz), and 3.1–32 dB (at 50 GHz) with respective minimum noise figures of 4.78, 5.12, and 6.15 dB. The respective RX 3-dB bandwidths are 20–27, 30–34.6, and 42–55.5 GHz. The measured CGPS gain variation at IF (2–4 GHz) is within 0.94 dB. This RX consumes 131 mW and occupies 1.22 mm<sup>2</sup> with pads in a silicon area.

A 0.12mm2 K/Ka Band RX Front-end in 40-Nm CMOS with Inductor-Less LO Generators

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A 90-98-ghz FMCW Radar Transceiver Supporting Broadband Modulation in 65nm CMOS

A 0.7-8 GHz High IF Frequency-Extended Transmitter Front-End with −47.1-Db EVM at 16 QAM in 65-Nm CMOS

A K/Ka/V Triband Single-Signal-Path Receiver With Variable-Gain Low-Noise Amplifier and Constant-Gain Phase Shifter in 28-nm CMOS

A 90‐ to 115‐ghz Superheterodyne Receiver Front‐end for W‐band Imaging System in 28‐nm Complementary Metal‐oxide‐semiconductor

A Highly Linearized Ka-band Heterodyne Receiver using a Folded Class-AB Inductive Peaking Mixer and Magnetic-Self-Cancellation-Transformer-Based IF Amplifiers

A Ka-Band Single-Chip SiGe BiCMOS Phased-Array Transmit/Receive Front-End

An Ultra-Compact Bidirectional Ka-Band Front-End Module with 3.8-Db NF and 13.5-Dbm OP1 Db

A mm-Wave Concurrent Dual-Band Dual-Beam Phased Array Receiver Front-End in 22-nm CMOS FDSOI

A 35-Ghz TX and RX CMOS Front-Ends for Ka-Band FMCW Phased-Array Radar Transceivers

A 0.07–3 GHz Wideband Front-End for SDR Receiver with 2.3 Db NF and 12 Dbm IIP<sub>3</sub> in 65 Nm CMOS

A Low-Power, Compact, 0.1–5.5-Ghz, 40-Dbm IB OIP3 LNTA-First Receiver for SDR

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

A 71-to-86GHz, 20.4dBm <tex>$\mathbf{P}_{\mathbf{out}}$</tex>, 6.0dB NF Transceiver with Quadrature Direct-Modulated Transmitter and Reflection-Less Heterodyne Receiver in 40nm CMOS

A 0.1∼4GHz receiver and 0.1∼6GHz transmitter with reconfigurable 10∼100MHz signal bandwidth in 65nm CMOS

5.1 A 5-to-16ghz Reconfigurable Quadrature Receiver with 50% Duty-Cycle LO and IQ-Leakage Suppression

A CMOS MedRadio Receiver RF Front-End with a Complementary Current-Reuse LNA

A 6-7 GHz, 40 Db Receiver RF Front-End with 4.5 Db Minimum Noise Figure in 0.13μm CMOS for IR-UWB Applications

A 71-to-86ghz, 20.4dbm $\mathbf{p}_{\mathbf{out}}$, 6.0db NF Transceiver with Quadrature Direct-Modulated Transmitter and Reflection-Less Heterodyne Receiver in 40nm CMOS

A Monolithic Dual-Band 77/94 GHz Transceiver Front-End with Shared Frequency Multiplier