Abstract:The proposed radio‐frequency receiver is a low‐IF receiver architecture, not a zero‐IF Rx, with the IF frequency being twice the channel bandwidth, that is, the intermediate frequency in the RF receiver equals 200 MHz. The radio‐frequency receiver consists of a low‐noise driver stage (RF stage) and an in‐phase/quadrature of phase (I/Q) demodulator. The low‐noise driver stage is designed using a complementary current‐reuse common‐gate configuration with shunt feedback to achieve wideband RF input matching with ultra‐low power dissipation, enhancing linearity compared to the conventional configuration. Summary This paper presents a battery‐free ultra‐low‐power (ULP), highly integrated, and wide‐bandwidth low‐IF radio‐frequency (RF) receiver designed for millimeter‐wave (mm‐Wave) applications, utilizing 130‐nm CMOS technology. The suggested RF receiver is suitable for K‐band (n258) at 26 GHz, Ka‐band (n261 and n257) at 28 GHz, and the LMDS band at 28 GHz in fifth‐generation applications. The proposed radio receiver consists of a low‐noise driver stage implemented using a complementary current‐reuse common gate with an active shunt feedback configuration and an in‐phase/quadrature‐phase (I/Q) demodulator. The proposed RF receiver employs transformer coupling to isolate the DC path between the transconductance stage (RF stage) and the switching stage (IF stage). The driver stage expands the RF input impedance while maintaining acceptable linearity and gain with ultra‐low DC power dissipation. The DC supplies for the proposed mm‐Wave RF receiver are generated using two novel energy‐harvesting voltage doubler circuits to provide positive and negative voltages. The proposed mm‐Wave radio receiver consumes 0.475 mW from a 1.1 V DC supply and exhibits a power conversion gain (CG) of 6.3 dB, with a 3 dB frequency bandwidth extending from 22 to 32 GHz. The input 1‐dB compression point (P1dB) of the RF receiver is −2.65 dBm, and the input third‐order intercept point (IIP3) is 7.35 dBm. With a sensitivity of −66.5 dBm at a 100 MHz channel bandwidth and a dynamic range of 63.85 dB, the suggested receiver demonstrates notable performance characteristics. The proposed radio receiver boasts an excellent figure of merit (FoM) at 215 dB, surpassing published works by a margin of 8–31 dB. The primary positive supply voltage is derived from a double‐band positive voltage doubler with series resonance feedback and parallel resonance networks, efficiently achieving the desired DC voltage and output current (1.1 V and 450 μA). Meanwhile, the negative gate bias is provided by a negative voltage doubler, ensuring the necessary negative voltage (−0.5 V) without any current conditions.

Self-demodulated receiver at MM-wave range using SiGe technology

A 60ghz BiCMOS Self-Demodulator with Injection Locked Oscillator

Low power high data rate GHz range receiver in 40nm CMOS technology

A 12-Mw 40–60-Ghz 0.18- $\mu {\hbox {m}}$ BiCMOS Oscillator-Less Self-Demodulator for Short-Range Software-Defined Transceivers

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

A 144 GHz 2.5mW multi-stage regenerative receiver for mm-Wave imaging in 65nm CMOS

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

D-band CMOS Transmitter and Receiver for Multi-Giga-bit/sec Wireless Data Link

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

SiP Ring Resonator Modulator-based Transmitters for Short-Reach Applications

High-speed Silicon Modulators for the 2 Μm Wavelength Band

A Silicon-Based Integrated Photonic-Assisted Emitter for High Date-Rate Microwave Wireless Communication

A Fully Integrated 0.18 Mu M Sige Bicmos Low Power 60 Ghz Receiver & Transmitter for High Data Rate Wireless Communications

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

SiGe2 Technology Advance for the RF Application

An 8mw Ultra Low Power 60ghz Direct-Conversion Receiver with 55db Gain and 4.9db Noise Figure in 65nm CMOS

High-Speed Receiver Based on Waveguide Germanium Photodetector Wire-Bonded to 90nm Soi Cmos Amplifier

A 131.5ghz, −84dbm Sensitivity Super-Regenerative Receiver by Zero-Phase-shifter Coupled Oscillator Network in 65nm CMOS

Battery‐free ultra‐low‐power radio‐frequency receiver for mm‐wave applications using 130‐nm CMOS technology with harvested DC supplies

A Fully Integrated 60ghz Four Channel CMOS Receiver with 7ghz Ultra-Wide Bandwidth for IEEE 802.11ad Standard

40Gbps Optical Receiver Based on Germanium Waveguide Photodetector Hybrid-Integrated with 90nm CMOS Amplifier