Abstract:State-of-the-art endoscopy systems require electronics allowing for real-time, bidirectional data transfer. Proposed are 2.4-GHz low-power transceiver analog front-end circuits for bidirectional high data rate wireless telemetry in medical endoscopy applications. The prototype integrates a low-IF receiver analog front-end [low noise amplifier (LNA), double balanced down-converter, bandpass-filtered automatic gain controlled (AGC) loop and amplitude-shift keying (ASK) demodulator], and a direct up-conversion transmitter analog front-end [20-MHz IF phase-locked loop (PLL) with well-defined amplitude control circuit, ASK modulator, up-converter, and power amplifier] on a single chip together with an internal radio frequency oscillator and local oscillating (LO) buffers. Design tradeoffs have been made over the boundaries of the different building blocks to optimize the overall system performance. All building blocks feature circuit topologies that enable comfortable operation at low power consumption. The circuits have been implemented in a 0.25-microm CMOS process. The measured sensitivity of the receiver analog front-end is -70 dBm with a data rate of 256 kbps, and the measured output power of the transmitter analog front-end could achieve -23 dBm with a data rate of 1 Mbps. The integrated circuit consumes a current of 6 mA in receiver mode and 5.6 mA in transmitter mode with a power supply of 2.5 V. This paper shows the feasibility of achieving the analog performance required by the wireless endoscopy capsule system in 0.25 microm CMOS.

Low Power High Data Rate Wireless Endoscopy Transceiver.

Low-power transceiver analog front-end circuits for bidirectional high data rate wireless telemetry in medical endoscopy applications

A 2.4ghz Low Power Wireless Transceiver Analog Front-End for Endoscopy Capsule System

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

D-band CMOS Transmitter and Receiver for Multi-Giga-bit/sec Wireless Data Link

A Low-Power, High Data-Rate CMOS ASK Transmitter for Wireless Capsule Endoscopy

Integrated D-Band Transmitter and Receiver for Wireless Data Communication in 65 Nm Cmos

Low Power Transmitter for Capsule Endoscope

A 2.4ghz Low Power ASK Transmitter for Wireless Capsule Endoscope Applications

Low-power Ultrawideband Wireless Telemetry Transceiver for Medical Sensor Applications.

An Ultra-Low Power 400mhz OOK Transceiver for Medical Implanted Applications.

A SoC with 3.9mW 3Mbps UHF transmitter and 240μW MCU for capsule endoscope with bidirectional communication

Low Power Ultra-Wideband Wireless Telemetry System for Capsule Endoscopy Application

Ultra low-power transceiver with novel FSK modulation technique and efficient FSK-to-ASK demodulation

A Low Power Digital Baseband for Wireless Endoscope Capsule

An ASK-Based IF Receiver for Wireless Endoscopy Capsule Systems

10 Mbps 0.3 Nj/bit OQPSK Transceiver IC for 400–450 MHz Medical Telemetry

A 400MHz/900MHz Dual-Band Ultra-Low-Power Digital Transmitter for Biomedical Applications

A 27-Mbps, 0.08-mm3 CMOS Transceiver with Simultaneous Near-field Power Transmission and Data Telemetry for Implantable Systems

A 7.2mw 15mbps Ask Cmos Transmitter For Ingestible Capsule Endoscopy

A 0.48mm2 Sub-2.4GHz Transceiver with Reused Matching Network and Duty-Cycle Controlled Class-E PA for Medical Band