Abstract:A fully integrated energy-efficient 10-Gb/s millimeter-wave transceiver with direct-modulation digital transmitter (TX) and I/ Q phase-coupled frequency synthesizer in 65 nm CMOS is presented. The transceiver consists of a direct-conversion receiver (RX), a digital TX with on-chip QPSK modulation, and a quadrature local-oscillation (LO) generation network with a 20-GHz phase-locked loop (PLL) frequency synthesizer. A T/R switch is integrated to interface with an E-shaped patch antenna. The QPSK modulation is directly realized in the I/ Q digital power amplifier (DPA), which simplifies the TX complexity and reduces the power consumption. A 20-GHz sub-sampling PLL (SSPLL) and a quadrature phased-coupled injection-locked oscillator (QILO) are integrated on-chip to generate 60-GHz quadrature LO signals. The QILO utilizes in-phase coupling technique to improve the LO I/ Q matching and phase noise performance. The RX achieves 7.1-dB noise figure (NF) and 25- to 47-dB dynamic gain range. The LO phase noise measured at the TX output is -115.6 dBc/Hz at 10 MHz offset from 60 GHz carrier. The measured error vector magnitude (EVM) of the TX is -23.9 dB for 10-Gb/s QPSK signals at 7-dBm output power. The EVM of the over-the-air (OTA) modulation-demodulation system is -13.8 dB for 10-Gb/s QPSK signals. The transceiver achieves the 10-Gb/s data rate while consuming 340.4 mW. The energy efficiency is 34 pJ/bit. This work demonstrates the fully functional wireless link based on the proposed mm-wave transceiver, which highlights the possibility of energy-efficient solution for future high throughputs mm-wave wireless systems.

A 400mhz 3-10mbps Transceiver Ic With Similar To 0.3 Nj/Bit Tx/Rx Energy Efficiency For Body Area Applications

A 400mhz 3–10mbps Transceiver IC with ∼0.3 Nj/bit TX/RX Energy Efficiency for Body Area Applications

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

Integrated D-Band Transmitter and Receiver for Wireless Data Communication in 65 Nm Cmos

A 0.66mw 400 MHz/900 MHz Transmitter IC for In-Body Bio-Sensing Applications.

A Highly Integrated Energy-efficient CMOS Millimeter-wave Transceiver with Direct-modulation Digital Transmitter, Quadrature Phased-coupled Frequency Synthesizer and Substrate-Integrated Waveguide E-shaped Patch Antenna

A 400MHz/900MHz Dual-Band Ultra-Low-Power Digital Transmitter for Biomedical Applications

Energy Efficient Transmitters For High Data Rate Biomedical Applications

An Energy-Efficient 10-Gb/s CMOS Millimeter-Wave Transceiver with Direct-Modulation Digital Transmitter and I/Q Phase-Coupled Frequency Synthesizer

An Energy Efficient Fully Integrated OOK Transceiver SoC for Wireless Body Area Networks

An ultra low power baseband transceiver IC for wireless body area networks

10 Mbps 0.3 Nj/bit OQPSK Transceiver IC for 400–450 MHz Medical Telemetry

A 90µW MICS/ISM band transmitter with 22% global efficiency

A 0.83-Pj/b 20-Gb/s/pin Single-Ended Transceiver with AC/DC-Coupled Pre-Emphasis FFE and Edge-Dependent Phase-Modulation DFE for Low-Power Memory Controllers

An Ultra-Low Power 400mhz OOK Transceiver for Medical Implanted Applications.

An Ultra Low Power Baseband Transceiver IC for Wireless Body Area Network in 0.18- \mu M CMOS Technology

A Sub-$100\ \mu\mathrm{w}$ RF Transmitter with 41% Global Efficiency Using Third-Harmonic Edge-Combining Technique and Class-E PA for Low-Power Biomedical Applications

A Sub-100 W RF Transmitter with 41% Global Efficiency Using Third-Harmonic Edge-Combining Technique and Class-E PA for Low-Power Biomedical Applications

A 780-MHz low power transceiver for wireless nodes applications in Internet of Things

A Sub-100 $\mu$ W MICS/ISM Band Transmitter Based on Injection-Locking and Frequency Multiplication

A 0.42-Mw 1-Mb/s 3- to 4-Ghz Transceiver in 0.18- $\mu \text{m}$ CMOS with Flexible Efficiency, Bandwidth, and Distance Control for IoT Applications