Abstract:This paper presents a low power Gaussian Frequency-Shift Keying (GFSK) transceiver (TRX) with high efficiency power management unit and integrated Single-Pole Double-Throw switch for Bluetooth low energy application. Receiver (RX) is implemented with the RF front-end with an inductor-less low-noise transconductance amplifier and 25% duty-cycle current-driven passive mixers, and low-IF baseband analog with a complex Band Pass Filter(BPF). A transmitter (TX) employs an analog phase-locked loop (PLL) with one-point GFSK modulation and class-D digital Power Amplifier (PA) to reduce current consumption. In the analog PLL, low power Voltage Controlled Oscillator (VCO) is designed and the automatic bandwidth calibration is proposed to optimize bandwidth, settling time, and phase noise by adjusting the charge pump current, VCO gain, and resistor and capacitor values of the loop filter. The Analog Digital Converter (ADC) adopts straightforward architecture to reduce current consumption. The DC-DC buck converter operates by automatically selecting an optimum mode among triple modes, Pulse Width Modulation (PWM), Pulse Frequency Modulation (PFM), and retention, depending on load current. The TRX is implemented using 1P6M 55-nm Complementary Metal-Oxide-Semiconductor (CMOS) technology and the die area is 1.79 mm2. TRX consumes 5 mW on RX and 6 mW on the TX when PA is 0-dBm. Measured sensitivity of RX is -95 dBm at 2.44 GHz. Efficiency of the DC-DC buck converter is over 89% when the load current is higher than 2.5 mA in the PWM mode. Quiescent current consumption is 400 nA from a supply voltage of 3 V in the retention mode.

A Highly Energy-Efficient Body-Coupled Transceiver Employing a Power-on-Demand Amplifier

A receiver analog front-end for body sensor network

A Re-Configurable Body Channel Transceiver Towards Wearable and Flexible Biomedical Sensor Networks

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

A 4-Mbps 41-pJ/bit On-off Keying Transceiver for Body-channel Communication with Enhanced Auto Loss Compensation Technique

A 400mhz 3–10mbps Transceiver IC with ∼0.3 Nj/bit TX/RX Energy Efficiency for Body Area Applications

A 400mhz 3-10mbps Transceiver Ic With Similar To 0.3 Nj/Bit Tx/Rx Energy Efficiency For Body Area Applications

A 0.66mw 400 MHz/900 MHz Transmitter IC for In-Body Bio-Sensing Applications.

An Energy Efficient Fully Integrated OOK Transceiver SoC for Wireless Body Area Networks

A Fully Integrated Bluetooth Low-Energy Transceiver with Integrated Single Pole Double Throw and Power Management Unit for IoT Sensors

Body-Channel Wireless Power Transfer Employing Transmitter-Side Received Power Monitoring and Maximum Point Tracking.

An ADPLL-centric Bluetooth Low-Energy Transceiver with 2.3mw Interference-Tolerant Hybrid-Loop Receiver and 2.9mw Single-Point Polar Transmitter in 65nm CMOS

A simple energy efficient transceiver for IEEE 802.15.4

A 70%-power transmission efficiency, 3.39 Mbps power and data telemetry over a single 13.56 MHz inductive link for biomedical implants

Wearable Vital Signal Monitoring Prototype Based on Capacitive Body Channel Communication

An Energy-Efficient ASIC with Real-Time Work-on-demand for Wireless Body Sensor Network

A 136μw over 800m Range Backscatter-Like UHF Band Transceiver

A 90µW MICS/ISM band transmitter with 22% global efficiency

Long-Term Energy Consumption and Transmission Delay Tradeoff in Wireless-Powered Body Area Networks

A 0.48mm2 Sub-2.4GHz Transceiver with Reused Matching Network and Duty-Cycle Controlled Class-E PA for Medical Band

A 6.3pJ/b 30Mbps -30dB SIR-tolerant Broadband Interference-Robust Human Body Communication Transceiver using Time Domain Signal-Interference Separation